Filter
Top Products
The Timer 23
The Timer
Tips
• To exit the standby
mode, press STANDBY
to make the t
indication disappear
from the display.
• The preset settings
remain until you reset
them.
• CFD-ZW770 only:
The backlight in the
display does not light
while the waking up
timer is on.
6 Set the volume by pressing TUNE•TIME SET + or
– , then DISPLAY ENT MEM.
7 Press STANDBY.
The t indication lights up and the power goes off.
At the preset time, the power will go on, and the
music will play. Then the power will go off at the
preset time, and the player will enter into the
standby mode.
To check/change when the playback will start
Press TIMER , then DISPLAY ENT MEM. Each time
you press DISPLAY ENT MEM, a stored setting is
displayed in the set order. To change the setting,
display the setting you want to change and re-enter it.
To use the player before a timer playback starts
Just turn on the player, and then you can use it.
If you turn off the player before the preset time, timer
playback will start at the preset time.
In case of the radio, however, if you listen to the
station which is different from the one you tuned in
in step 1 on page 22, you will hear that station at the
preset time. Make sure to tune in the station you want
to listen to before you turn off the player.
To stop play
Press POWER to turn off the power.