Filter
Top Products
30
Presetting radio stations
4
Press DISPLAY/MENU for 2
seconds or more.
The CD player starts scanning the
stations from the lower frequencies and
stops for about 3 seconds when a station
is received.
5
If you want to preset the received
station, press DISPLAY/MENU
while the preset number is
flashing.
The received station is preset on the
preset number 1 and the CD player starts
scanning for the next receivable station.
If you do not press DISPLAY/MENU
within the 3 seconds, the CD player will
start scanning for the next receivable
station without storing the station.
6
Repeat step 5 until all receivable
stations are preset.
If the stations have already been stored,
the newly preset stations will replace the
old ones.
Presetting stations manually
1 Press RADIO ON/BAND to turn on the
radio.
2 Press RADIO ON/BAND to select the
band.
3 Press and hold MEMORY until the preset
number flashes in the display.
87.50 MHz
FM 01
From this step on, start the next operation
within 30 seconds after you finished the
previous operation. If 30 seconds pass
with nothing done, the preset number
stops flashing which shows that the CD
player has exited the preset memory
standby mode. If this happens, start from
step 3 again.
4 Push the 5-way control key toward .
or > repeatedly to select the preset
number you want to store the station on
while the preset number flashes.
5 Press TUNE + or – ( + or – for the
remote control) to tune in the station you
want while the preset number flashes.
6 Press DISPLAY/MENU.
When the station is preset successfully,
the beep sounds. The new station replaces
the old one.
The preset number increases by one and
the CD player enters the preset memory
standby mode.
7 Repeat steps 4 to 6 when you preset the
stations in the same band. When you
preset the stations in the different band,
press and hold MEMORY to exit the
preset memory standby mode. Repeat
steps 2 to 6 after the preset number stops
flashing.