Filter
Top Products
RDP-V20iP [GB]
4-288-623
-32(1)
The rechargeable battery charges too quickly, or
the rechargeable battery loses its charge quickly.
If the battery is charged in an extremely cold or hot
environment which is beyond the system’s operating
temperature range, charging may complete within a
short time. In this case, battery endurance will be
shorter than usual. Charge the battery in an
environment where the temperature range is 5 ºC to
35 ºC.
There is no sound, or the sound is very low.
The volume is set to minimum. Increase the volume.
The volume of the connected device is low. Increase the
volume of the device.
The system outputs sound at a lower volume when
using the rechargeable battery, compared to when using
the AC adaptor.
Two different music sources are mixed together
during playback.
Stop playback of either your iPod or audio input device
and remove/disconnect it from the system.
There is a severe hum or noise.
The system is placed next to a TV or other device that
emits audio. Move the system away from the other
device, and connect the AC power cord (mains lead) to
a different power outlet.
When playing both an iPod and an audio input device
(connected to the AUDIO IN jack), noise may occur.
Remove/disconnect the iPod or the audio input device.
The sound is distorted.
The volume is too high. Decrease the volume.
The volume of the connected device is too high.
Decrease the volume of the device.
The bass boost or equalizer functions of the connected
audio input device are being used. Disable the functions.
Make sure the iPod is connected securely.
When playing both an iPod and an audio input device
(connected to the AUDIO IN jack), the sound may be
distorted. Remove/disconnect the iPod or the audio
input device.
The POWER indicator (green) flashes.
When you press on the system, adjust the volume,
or when signals from the remote commander are
received, the POWER indicator (green) may flash. This
is not a malfunction.
Radio signals, etc., cannot be received.
If connecting a device with a built-in radio or TV tuner
to the system, radio broadcasts or TV sound may not be
received, or reception may be reduced significantly.
The system is inoperable even though it is turned
on.
Restart the system by pushing the “RESET” button on
the bottom of the system by using a pin, etc. If the
system does not restart, contact your nearest Sony
dealer.
iPod
There is no sound, or the sound is very low.
The iPod is not firmly connected to the system. Remove
the iPod, and then reconnect it.
The iPod is set to “Volume Limit.” Adjust or disable the
“Volume Limit” setting.
The iPod is not playing. Begin playback.
The iPod does not function.
Make sure the iPod is connected securely.
Make sure the iPod is updated with the latest software.
If not, update the iPod before using it with the system.
The iPod cannot be charged.
Make sure the iPod is connected securely.
Make sure the AC adaptor is connected firmly.
The ring volume of the iPhone does not change.
Adjust the ring volume on the iPhone.
Audio-in
There is no sound, or the sound is very low.
The cable is loose. Check the connection.
The cable is not firmly connected to the AUDIO IN jack.
Disconnect the cable, and then plug it in again.
Remote commander
The remote commander does not function.
Make sure that you are pointing the remote commander
at the remote sensor on the system.
The remote commander is too far away from the
system. Move the remote commander closer to the
remote sensor on the system to perform remote
operations.
There is an obstacle in front of the remote sensor.
Remove the obstacle blocking the remote sensor.
The iPod is not firmly connected. Remove the iPod, and
then reconnect it.
The battery of the remote commander is depleted.
Replace it with a fresh battery.
A strong light source such as direct sunlight or a high-
frequency fluorescent light is shining into the remote
sensor. Do not place the system near a strong light
source.
The system cannot be turned on by pressing /
on the remote commander.
The / button on the remote commander can turn on
the system only when the AC adaptor is used.
The battery will not fit into the remote
commander.
The battery is backwards. Check the polarity (+/−) and
insert it correctly.
System protection mode
Under the following conditions, all indicators on the
system flash repeatedly and all buttons of the system and
the remote commander (except the / button on the
system) do not function.
The inside of the system is hot. Use the system within
the designated temperature range (5 ºC to 35 ºC).
The system is receiving excess voltage. Be sure to use the
supplied AC adaptor. Do not supply other than 13 V of
power to the system.
The built-in rechargeable battery is malfunctioning.
In this case, press / on the system to turn the system
off, and then press / again to turn it on. If the system is
extremely hot, wait for the system to cool down before
turning it on.
Note
If the indicators do not turn off after you have turned
the system off/on several times at short intervals,
disconnect the AC adaptor from the wall outlet (mains)
and leave the system turned off for a while. If the
problem persists, contact your nearest Sony dealer.
Specifications
Speaker section
Speaker system
Woofer: 56 mm magnetically shielded
Tweeter: 20 mm
Enclosure type
Bass reflex
Impedance
Woofer: 6 Ω
Tweeter: 6 Ω
Amplifier section
Reference output power
13 W (10% T.H.D., 1 kHz, 6 Ω, AC adaptor
operation)
Input Dock connector for iPod (30-pin) × 1, stereo
mini jack × 1
Input impedance
4.7 kΩ (at 1 kHz)
Section for iPod
DC out 5 V
MAX 1 A
General
Power DC 13 V (AC adaptor supplied)
Operating temperature
5 ºC - 35 ºC
Power voltage
100 V - 240 V AC
Dimensions (w/h/d)
Approximately 145 mm × 145 mm × 145 mm
Mass Approximately 600 g
Supplied accessories
AC adaptor (AC-E1320D1) (1)
AC power cord (1)
Remote commander (1)
CR2025 lithium battery (1) (preinstalled in the
remote commander for trial use)
Attachment (3) (One is preinstalled to the
system.)
Reference Guide (this document) (1)
Startup Guide (1)
Design and specifications are subject to change without
notice.
Before operating the system, please read this guide thoroughly
and retain it for future reference.
WARNING
To reduce the risk of fire, do not cover the ventilation
opening of the apparatus with newspapers, tablecloths,
curtains, etc. Do not place the naked flame sources such as
lighted candles on the apparatus.
To reduce the risk of fire or electric shock, do not expose
this apparatus to dripping or splashing, and do not place
objects filled with liquids, such as vases, on the apparatus.
Do not install the appliance in a confined space, such as a
bookcase or built-in cabinet.
Do not expose batteries or apparatus with battery installed
to an excessive heat such as sunshine, fire or the like.
As the main plug is used to disconnect the unit from the
mains, connect the unit to an easily accessible AC outlet.
Should you notice an abnormality in the unit, disconnect
the main plug from AC outlet immediately.
The system is not disconnected from the mains as long as
it is connected to the AC outlet, even if the system itself
has been turned off.
The nameplate is located on the bottom exterior of the
system.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
WARNING
Replace the battery for the remote commander with a
Sony CR2025 lithium battery only. Use of another
battery may present a risk of fire or explosion.
Battery may explode if mistreated. Do not recharge,
disassemble or dispose of in fire.
Dispose of used battery promptly. Keep away from
children.
Notice for customers: the following information
is only applicable to equipment sold in countries
applying EU directives
The manufacturer of this product is Sony Corporation, 1-
7-1 Konan Minato-ku Tokyo, 108-0075 Japan. The
Authorized Representative for EMC and product safety is
Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327
Stuttgart, Germany. For any service or guarantee matters
please refer to the addresses given in separate service or
guarantee documents.
Disposal of Old Electrical &
Electronic Equipment (Applicable in
the European Union and other
European countries with separate
collection systems)
This symbol on the product or on its packaging indicates
that this product shall not be treated as household waste.
Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of
correctly, you will help prevent potential negative
consequences for the environment and human health,
which could otherwise be caused by inappropriate waste
handling of this product. The recycling of materials will
help to conserve natural resources. For more detailed
information about recycling of this product, please contact
your local Civic Office, your household waste disposal
service or the shop where you purchased the product.
Disposal of waste batteries
(applicable in the European Union
and other European countries with
separate collection systems)
This symbol on the battery or on the packaging indicates
that the battery provided with this product shall not be
treated as household waste.
On certain batteries this symbol might be used in
combination with a chemical symbol. The chemical
symbols for mercury (Hg) or lead (Pb) are added if the
battery contains more than 0.0005% mercury or 0.004%
lead.
By ensuring these batteries are disposed of correctly, you
will help prevent potentially negative consequences for the
environment and human health which could otherwise be
caused by inappropriate waste handling of the battery. The
recycling of the materials will help to conserve natural
resources.
In case of products that for safety, performance or data
integrity reasons require a permanent connection with an
incorporated battery, this battery should be replaced by
qualified service staff only.
To ensure that the battery will be treated properly, hand
over the product at end-of-life to the applicable collection
point for the recycling of electrical and electronic
equipment.
For all other batteries, please view the section on how to
remove the battery from the product safely. Hand the
battery over to the applicable collection point for the
recycling of waste batteries.
For more detailed information about recycling of this
product or battery, please contact your local Civic Office,
your household waste disposal service or the shop where
you purchased the product.
The validity of the CE marking is restricted to only those
countries where it is legally enforced, mainly in the
countries EEA (European Economic Area).
Precautions
To disconnect the AC adaptor, pull it out by the plug,
not the cord.
Although this system is magnetically shielded, do not
leave recorded tapes, watches, personal credit cards, or
floppy disks with magnetic coding in front of the system
for an extended period of time.
Do not leave the system in a location near heat sources,
or in a place subject to direct sunlight, excessive dust,
moisture, rain or mechanical shock.
Allow adequate air circulation to prevent internal heat
build-up. Do not place the system on a surface (a rug, a
blanket, etc.) or near materials (a curtain) which might
block the ventilation holes.
Do not insert any small objects, etc., into the jacks or
ventilation hole on the rear of the system. The system
may short out or malfunction.
When installing, do not cover the ventilation hole on
the rear of the system. Sound quality may be altered.
Should any solid object or liquid fall into the system,
unplug the system and have it checked by qualified
personnel before operating it any further.
Do not handle the system with wet hands.
Do not place the system anywhere near water.
If the TV picture or monitor display is
magnetically distorted
Although this system is magnetically shielded, there may
be cases that the picture on some TV sets/personal
computers may become magnetically distorted. In such a
case, turn off the power of the TV set/personal computer
once, and after 15 to 30 minutes turn it on again. In the
case of a personal computer, take appropriate measures
such as data storage before turning it off.
If no improvement is apparent, locate the system farther
away from the TV set/personal computer. Furthermore, be
sure not to place objects in which magnets are attached or
used, such as audio racks, TV stands, toys, etc., near the
TV set/personal computer. These may cause magnetic
distortion to the picture due to magnetic interaction.
NOTES ON LITHIUM BATTERY
Wipe the battery with a dry cloth to assure a good
contact.
Be sure to observe the correct polarity when installing
the battery.
Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
Note
In the Reference Guide, “iPod” is used as a general
reference to functions on an iPod or iPhone, unless
otherwise specified by the text or illustrations.
If you have any questions or problems concerning your
system, please consult your nearest Sony dealer.
Troubleshooting
Should you encounter a problem with your system, find
your problem in the troubleshooting checklist below and
take the suggested corrective action. If the problem
persists, contact your Sony dealer.
General
The power does not turn on when the AC adaptor
is connected.
Make sure the AC adaptor is connected to the wall
outlet (mains) firmly.
The power does not turn on when the AC adaptor
is disconnected, or the BATT indicator (amber)
flashes several times and then the power of the
system turns off.
The rechargeable battery may be depleted. In this case,
connect the AC adaptor to charge the battery. (See “To
prepare a power source.”)
The rechargeable battery is depleted.
Connect to the AC adaptor to charge the battery.
Personal Audio Docking System
4-288-623-32(1)
RDP-V20iP
©2011 Sony Corporation Printed in China
Reference Guide