Filter
Top Products
NW-A805/A806/A808/NWZ-A815/A816/A818
9
3-5. NAND BOARD, SVX SWITCH FLEXIBLE (PWB ASSY)
3-6. NOTE WHEN INSTALLING THE SVX SWITCH FLEXIBLE (PWB ASSY)
Note: Follow the assembly procedure in the numerical order given.
4
Turn up the LCD flexible board.
1
two claws
2
Lift up the
SVX swtch flexible (PWB assy).
5
Lift up the NAND board.
3
two screws (M1.4)
9
sheet (NAND)
qa
NAND board
q;
spacer (NAND)
6
Remove three solders.
8
SVX swtch flexible (PWB assy)
7
insulating sheet
(NW-A805/A806/
NWZ-A815/A816 only)
– rear view –
2
Holding the bent part,
rotate the
SVX swtch flexible (PWB assy)
by 3 or 4 turns in the arrow direction,
and twist to bind the lead wires.
About 45
°
1
Bend the switch flexible board.
4
Push the lead wires completely into a space
between front cabinet assy and LCD holder.
3
Holding the bent part, push in the
SVX swtch flexible (PWB assy)
until it gets stuck by two claws
of the front cabinet assy.
Note: Route the lead wires as shown in the figure,
and solder them at the angle shown in the figure.
Note: The soldering height
should be less than 0.8 mm.
About 45
°
SVX swtch flexible (PWB assy)
NAND board
lead wire (red)
lead wire (gray)
lead wires
front cabinet assy
claw
lead wire (black)
claw
LCD holder
– rear view –
Ver. 1.4