2
NSZ-GT1
4-196-880-12(1)
C:\work\btv\ReferenceGuide\Eagle_rev0614\4196880121\4196880121NS
ZGT1U2\020WAR.fm
masterpage:Left
To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or
moisture.
The AC power cord must be changed only
at a qualified service shop.
Batteries or batteries installed apparatus
shall not be exposed to excessive heat
such as sunshine, fire or the like.
CAUTION
The use of optical instruments with this
product will increase eye hazard. As the
laser beam used in this Internet TV Box is
harmful to eyes, do not attempt to
disassemble the cabinet. Refer servicing
to qualified personnel only.
This label is located on the laser protective
housing inside the enclosure.
This symbol is intended to alert
the user to the presence of
uninsulated “dangerous
voltage” within the product’s
enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
This symbol is intended to alert
the user to the presence of
important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.
These graphical symbols are located on
the AC adapter.
NOTE
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
Precautions
• To prevent fire or shock hazard, do not
place objects filled with liquids, such as
vases, on the apparatus.
• The set is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the
set itself has been turned off.
• Install this unit so that the AC power cord
can be unplugged from the wall socket
immediately in the event of trouble.
• The nameplate is located on the bottom
of the unit.
Installing
• Do not install this equipment in a
confined space, such as a bookshelf or
similar unit.
FCC WARNING
You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
This transmitter must not be co-located or
operated in conjunction with any other
antenna or transmitter.
The shielded Interface cable must be used
with the equipment in order to comply with
the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
FCC Radiation Exposure
Statement:
This equipment complies with FCC
radiation exposure limits set forth for
uncontrolled equipment and meets the
FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65. This
equipment should be installed and
operated with at least 20 cm and more
between the radiator and person's body
(excluding extremities: hands, wrists, feet
and ankles).
This device is restricted to indoor use when
operated in the 5.15 to 5.25 GHz frequency
range.
This product contains FCC ID: GT3FC009
Owner's Record
The model and serial numbers are located
at the bottom of the unit. Record the serial
number in the space provided below.
Refer to them whenever you call upon your
Sony dealer regarding this product.
Model No.______________
Serial No.______________
For Customers in the USA
If this product is not working properly,
please call 1-800-222-7669.
WARNING
Operation is subject to the following two
conditions;
(1)this device may not cause
interference, and
(2)this device must accept any
interference received,
including interference that may cause
undesired operation of the device.
010COV.book Page 2 Thursday, June 17, 2010 4:17 PM