Filter
Top Products
Symptom Cause and/or corrective action
The CD does not play, or “No Disc”
appears on the display when a CD
is placed in the player.
The CD is dirty or defective. Clean it or change it.
Check that the CD is inserted with the label side up
(
page 15).
Moisture condensation has occurred. Leave the CD player
aside for several hours until the moisture evaporates.
Close the lid of the battery compartment firmly (
page 12).
Make sure the battery is inserted correctly (
page 12).
Connect the AC power adaptor to an AC outlet securely
(
page 14).
Press /ENTER after one second or more has passed since
the AC power adaptor was connected.
The CD-R/CD-RW in the player is blank.
There is a problem with the quality of the CD-R/CD-RW,
recording device, or application software.
“HOLD” flashes on the display
when you press a button, and the
CD does not play.
The buttons are locked. Slide the HOLD switch back
(
page 17).
Playback starts from the point you
stopped (resume function).
The resume function is working. To start play from the
first track, press and hold /ENTER ( on the rotary
commander) while the player is stopped until the first track
starts playing, or open the lid of the player (
page 16). Or,
remove all power sources, and then insert the battery or connect
the AC power adaptor again.
During playback of an ATRAC
CD or MP3 CD, the CD does not
rotate but you can hear the sound
normally.
This player is designed to stop the rotation of an ATRAC CD
or MP3 CD during playback to reduce the power consumption.
The player is not malfunctioning.
“No File” appears on the display
after you press /ENTER or
when the lid of the player is
closed.
There are no ATRAC3plus/MP3 files on the CD-R/CD-RW.
A CD-R/CD-RW from which the data has been erased is being
used.
The CD is dirty.
The LCD display becomes hard to
see or slows down.
You are using your CD player at high temperatures (above
40°C/104°F) or at low temperatures (below 0°C/32°F). At
room temperature, the display will return to its normal
operating condition.
Even though you have not selected
“BOOKMARK,” (Bookmark)
flashes.
If you have selected a playback option other than
“BOOKMARK,” (Bookmark) flashes.
Play stopped abruptly.
The off timer has been set. Change the setting of “TIMER” to
“OFF” (
page 27).
The dry battery is used up completely. Replace the dry battery
with a new LR6 (size AA) alkaline battery (
page 12).
You cannot operate the player,
and a sequence of 8 numbers or
letters appear on the display of the
CD player.
This phenomenon may occur, depending on the CD you are
using. Remove all power sources, and then insert the battery
or reconnect the AC power adaptor. Try to operate the player
again. If the problem persists, consult your nearest Sony dealer.
30
D-NE321CK/NE326CK.GB.2-318-870-11(1)