Sony HS128 MP3 Player User Manual


 
17
Additional information
Troubleshooting
If you experience any of the following difficulties while using your player, use this
troubleshooting guide to help you to remedy the problem. Should any problem persist, consult
your nearest Aiwa dealer.
For trouble concerning operations while connected to your computer, also refer to
“Troubleshooting” in the separate manual for the “Music Transfer pavit Edition” software.
Operation
Symptom
There is no sound.
The buttons do not work.
The volume will not
increase.
The sound is distorted.
Playback stops suddenly.
There is noise in the
playback sound.
The LED indicator flashes red
even though the battery has
just been replaced.
Cause/Remedy
c The volume level is set to the minimum level.
Increase the volume (page 10).
c The HOLD function is activated.
Release the HOLD function (page 14).
c The player contains moisture condensation.
Let your player sit for a few hours.
c The battery is exhausted.
Replace the battery with a new one (page 7).
c The HOLD function is activated.
Release the HOLD function (page 14).
c The bit rate used when encoding the MP3 files was low.
Transfer MP3 files encoded with higher bit rates to the “pavit.”
c The M.D.S.E function is turned on.
Turn off the M.D.S.E function (page 13).
c The battery is exhausted.
Replace the battery with a new one (page 7).
c The audio data itself contains noise.
Noise may have been introduced when creating audio data due to
the conditions of the computer. Create the audio data again.
c The player is not functioning normally.
Remove the “pavit” from the player and hold down Nx for more
than 5 seconds to reset the player.
c Send the audio data to the “pavit” again, as the data stored in the
“pavit” may have been destructed.
(Continued)