Filter
Top Products
Setting Alarm 2
4) Once alarm AL1 has been set, slide “ALARM SELECTOR“ (1) to AL2 position. , the
alarm indicator “AL2“ (13) will light up.
5) Slide the “ALARM SELECTOR“ (1) to AL2 position, the alarm indicator “AL2“ (13) will
light up.
6) Press and hold the “ALARM SET /OFF“ (5) button and at the same time press the
“FAST“ Button (6) or the “SLOW“ button (7) to advance clock display until you reach
desired alarm setting.
Selecting 12 or 24 hours format – Clock is set to 12 hour as the default setting
Press and hold the Fast Button (9) for 6 seconds to enter the hour selection mode,
release the Fast Button (9) when the display shows "12 H" or "24 H". Press and release
the hour button to toggle between 12 or 24 hours. If no selection is made within 4 seconds,
then the last displayed hour format will be chosen and the display will return to the normal
Time mode.
Alarm –
Enable Alarms:
1) To enable Alarm 1, slide the “ALARM SELECTOR“ (1) to AL1 position. the alarm
indicator “AL1“ (12) will light up.
2) To enable Alarm 2, slide the “ALARM SELECTOR“ (1) to AL2 position, the alarm
indicator “AL2“ (13) will light up.
3) To enable both alarms, slide the “ALARM SELECTOR“ (1) to AL2 position, the alarm
indicators “AL1“ (12) and “AL2“ (13) will light up.
To Select Wake up mode
To select the wake up mode, slide the “Alarm Mode Switch“ (11) to your desired position:-
a) “BUZZ“ for sound b) “VIB“ for bed shaker c) “VIB/ BUZZ“ for both sound and bed
shaker
NOTE: once the wake up mode is chosen, this will apply to both alarms.
Alarm Patterns –
When the alarm is activated, alarm pattern of the buzzer / flashing display will be out of sync
with the vibrator. This means that when the buzzer / flashing display is ON, the vibrator will
be OFF and while the buzzer/ flashing display is OFF, the vibrator will be ON.
ALARM 1 - When Alarm 1 is activate, it will have 3 beeps for buzzer, then the vibrator.
This pattern is repeated until the alarm is stopped.
ALARM 2 - When Alarm 2 is activate, it will have 4 beeps for buzzer, then the vibrator.
This pattern is repeated until the alarm is stopped.
Adjusting The Alarm Duration Time
The default alarm duration time setting is 30 minutes; you may adjust the alarm duration
between 1 minute and 59 minutes as desired. To adjust the alarm duration:
• Press and hold the AL. SET button (5) for six seconds. The clock display will show the
default alarm duration as ‘30’. Release the AL set button
• Press the “ MIN” button (10) to adjust the alarm duration to the desired setting, from 1
minute to 59 minutes.
• When the display is showing the desired alarm duration time, it will return to the normal
clock mode after 3 seconds. The new alarm duration time setting becomes the new
default and remains in the memory until you change it again.
Snooze Operation –
1. When the alarm turns on in the morning you may press the SNOOZE Button (8) to stop
the alarm temporarily. The alarm will shut off for 9 minutes or for the predetermined time
you select from 1-30 minutes, and then turn on again. The snooze operation may be
repeated indefinitely until the alarm is turned off.
2. The SNOOZE function of Alarm 1 and Alarm 2 is independent of each other.