Filter
Top Products
LED ALARM CLOCK WITH VIBRATOR
MODEL SB200SS
OPERATION INSTRUCTIONS
IMPORTANT- Please read these instructions carefully before use and retain for future
reference.
FEATURES
1) Alarm indicator 2) PM indicator
3) Snooze Button 4) Volume control
5) Alarm Set/Off Button 6) Time Set Button
7) Alarm Off Button 8) On/Off Vibrator Buzz
9) Hour Button 10) Minute Button
11) Tone Control 12) Display Hi/Lo
13) AC 9v input 14) Vibrator input
Setting the correct time-
1) Press and hold the TIME button (6) at the same time press the HOUR button (9)
to advance the clock display rapidly until the hour is correct.
2) Press and hold the TIME button (6) at the same time press the MIN button (10) to
advance the minute until the correct time is shown.
3) A lighted dot (2) in the upper left of clock display indicates time is PM. For AM
time indication, there is no lighted dot.
Setting the alarm time-
1) Simply follow the instructions mentioned under “ Setting the correct time”
except that you will have to press the AL set button (5) instead of the TIME
button.
2) Make sure the alarm time is correctly set for AM or PM, lighted dot (2)
indicates PM. Be sure to release the HOUR and MIN set buttons before
releasing the ALARM button.
Snooze Operation-
SNOOZE button (3) press after alarm has sounded. The alarm will be turned off
for 9 minutes for extra sleep. The alarm will come back again after 9 minutes.
You may repeat this cycle many times up to 59 minutes maximum.
Alarm-
Set the alarm time you wish and slide the VIB / BUZZ, VIB, BUZZ, OFF (8)
switch to the desired position. VIB / BUZZ for both vibrator & sound, or VIB for
vibrator only or BUZZ for sound only. To turn alarm off select the OFF position.
Tone-
Adjust the tone (11) by rotating the tone wheel located at the top right-hand side.
Adjust from left to right for desired tone pitch.
Volume-
To adjust the volume (4) rotate the wheel located on the front right hand side
bottom corner. The higher the number the louder the volume.
Bed Shaker (Vibrator) - See Figure B
1) Attach the bed shaker input jack to the back of clock at VIBRATOR input.
2) To set vibrator for alarm slide switch (8) to desired position.
3) Put vibrator under mattress or pillow.
AC-9V Power Input -
Attach the AC power supply input to the back of clock at AC-9V IN next to the
VIBRATOR input.
Battery Backup-
To use battery backup, you can install a 9-volt alkaline battery in the back of the
clock. Located under the left side slide the battery access cover to the left and install
battery. Battery not included.
GENERAL DATA
Power: 110 Volts, Consumption 8 watts, 60Hz
UL listed transformer (Underwriters Laboratories)
Made in China
Sonic Alert 1050 East Maple Rd. Troy, MI 48083
www.SonicAlert.com
1-800-566-3210 V/TTY