Filter
Top Products
- 5 -
4. Mark the four points for the drillholes with
a pencil.
5. Mark the drillhole with a mandril.
6. Firmly secure the mounting plate
q
with the
supplied screws.
7. Hold the kitchen radio slanted, with the two
recesses in the retaining lugs on the mounting
plate
q
. Press the kitchen radio upwards until
it audibly engages.
Secure the wire antenna with a piece of adhesive
tape such that it does not hang down.
Setting up the kitchen radio
Do not set the kitchen radio up without the mounting
plate
q
. Otherwise the speakers are covered and
the sound is scarcely audible.
To set up the kitchen radio with the enclosed mounting
plate
q
:
1. Simultaneously press the two retaining levers
w
on the back of the appliance down. Push the
mounting plate
q
back and remove it.
2. Push the two retainer lugs on the mounting plate
q
into the recesses on the lower rear side of the
kitchen radio.
3. Firmly press the front part of the mounting plate
q
down until you hear it engage. You can now
set up the radio.
To disassemble the mounting plate
q
, grip the
mounting plate
q
from below with the thumbs and
press it forwards and up until it disengages. You can
now remove the mounting plate
q
.
Commissioning
Inserting the back-up batteries
The back-up batteries ensure that the programmed
time, date, alarm time and set SDAs (Special Day
Alert) are not erased in the event of a power failure.
For this, you require two 1.5V batteries of type
AAA. They are not supplied with the appliance.
1. Open the lid of the battery compartment
a
on the underside of the kitchen radio.
2. Insert the batteries. Make sure the polarities
are correct.
3. Close the lid of the battery compartment
a
.
The lid must audibly engage.
Note:
The back-up batteries must be checked at least
once per year and, if necessary, exchanged
for new ones.
Providing mains power
• Insert the plug into a power socket. In the
display, the time is indicated by "00:00.
00".
To be able to use the alarm functions of the radio,
first of all programme in the date and time, as
described in the following section.
IB_KH2281_Ar5027_LB4 15.07.2008 9:07 Uhr Seite 5