Filter
Top Products
24 - English
System Setup
Auto Clock Set
This menu is used to set the current time. You need to set
the time to use timer recording.
With the unit in Stop mode, press the MENU button.
1
Select Clock Set using the ❷buttons, then press
the
❿ or ENTER button.
3
Select Auto Clock Set using the ❷buttons, then
press the
❿ or ENTER button.
4
Select the sub menu (Clock Data CH, Time Zone or
Daylight Saving) using the
❷ buttons, then press
the
❿ or ENTER button.
5
No Disc Clock Set
Manual Clock Set
Auto Clock Set
No Disc
No Disc
No Disc
Auto Clock Set
Time Zone : Automatic
Daylight Saving : Automatic
Clock Data CH : Automatic
No Disc
Clock Data CH
Select channel :
Auto
Using the ❷buttons, move the selection bar to
“Setup” then press Enter to select.
2
Clock Data CH
Select a channel that carries a time signal using the
❷buttons then press the ❿or ENTER button.
Select Auto to set the channel automatically.
Note
You must have the antenna connected to set the
Auto Clock. See page Antenna Connections
The Clock will be automatically set when you turn
off the recorder.