Filter
Top Products
Setting the standby time
Ensure that the receiver is switched off. Press the mode button (5) once,
the
STANDBY
symbol in the display will start to flash.
Press and hold down the mode button (5) until the
STANDBY
symbol and the
time shown in the display begin to flash. Release the mode button. You now
have 5 seconds to start the next procedure otherwise the display will stop
flashing and return to showing normal time.
While the display is flashing use the tuning up button (12) to adjust the
minutes and the tuning down button (15) to adjust the hours. After approx.
5 seconds the display will stop flashing and return to a normal time display.
The time is displayed in 24 hour format.
Waking up to the bleeper
Set the standby time as previously described. Set the standby switch (21)
to the 'bleep' position. Press the standby button (4) until the
STANDBY
symbol is shown in the display.
When the standby time is reached the bleeper will sound. The bleeper will
continue to sound for approx. 59 minutes or until the power button (14) is
pressed. The standby time (alarm) can be permanently switched on or off
by pressing the standby button (4). When the
STANDBY
symbol is
visible in the display, the standby time (alarm) is active.
Waking up to the radio
Set the standby time as previously described. Tune the radio to the required
station and set the volume level. Set the standby switch (21) to the 'radio'
position. Press the standby button (4) until the
STANDBY
symbol is
shown in the display.
When the standby time is reached the radio will turn on and will continue to
operate for approx. 59 minutes or until the power button (14) is pressed.
The standby time (alarm) can be permanently switched on or off by pressing
the standby button (4). When the
STANDBY
symbol is visible in the
display, the standby time (alarm) is active.
STANDBY
STANDBY
6