Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
15
Checking the Alarm Times
1. To check Alarm 1 time, set the Alarm 1 function switch to the 'Adj'
position. Alarm 1 time will show in the display.
2. Return the Alarm 1 function switch to its previous position. The
display will revert to showing time.
3. To check Alarm 2 time, set the Alarm 2 function switch to the 'Adj'
position. Alarm 2 time will flash in the display.
4. Return the Alarm 2 function switch to its previous position. The
display will revert to showing time.
Note: Incorrect display will result if both the Alarm function switches
are set to the 'Adj' position.
Setting Alarm 2
1. Slide the Alarm 2 function switch to the 'Adj' position. Alarm 2 time
will show in the display.
2. Press the F.Fwd button to increase the time at a fast rate. The
S.Fwd button will increase the time at a slow rate. The F.Rev and
S.Rev buttons decrease the time at fast and slow rates. Release the
buttons when the correct time is reached. The clock uses a 12 hour
display with a PM indicator. Ensure that the correct 12 hour cycle
is selected.
3. Slide the Alarm 2 function switch to the 'On' position. The display
will revert to showing time and the Alarm 2 indicator will light.
2
2
2
2
1
3
1
3
cr9970 instruction book.PMD 6/11/2004, 10:57 AM15