Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Listening to the Radio
1. Switch on the radio by sliding the Function switch to the 'On'
position. The LED dial pointer will light up indicating that the radio
is switched on.
2. Select the required waveband using the Waveband selector switch.
3. Tune in to the desired station by rotating the Tuning control. The
station frequency is indicated by the LED dial pointer.
The Wire aerial located on the rear of your clock radio is for FM
reception. The wire should be fully extended and positioned for
optimum reception.
For MW and LW reception there is a built in ferrite aerial. Rotate your
clock radio to the position giving best reception.
4. Adjust the volume by rotating the Volume control.
5. The radio can be switched off by sliding the Function switch to the
'Off' position.
Note: if the radio does not switch off, this may be caused by inadvertent
operation of the Sleep button. Press the Alarm/Off button to cancel.
4