Filter
Top Products
If you need any further advice, please
call our Technical Helpline on
0181 758 0338 (Mon-Fri)
6
Dual alarm
If you require the alarm to operate at two different times on one day, first
position the Alarm switch to 'AL1' and set the required alarm time. Then
move the Alarm switch to 'AL2' and set the second desired alarm time.
When both alarms have been set, move the alarm switch to 'AL1+2'.
Ensure that the Function switch is in the 'Alarm' position. The display
alarm indicators will both be lit and the alarms will now operate at the
programmed time.
Once the 'AL1' has operated, press the Time/Alarm off button once. The
alarm/radio will switch off and will operate again at a preselected 'AL2'
time. Press the Time/Alarm off button again to cancel. AL1 and AL2 will
sound again the next day unless the function switch is set to 'Off'.
Wake to alarm
Once the alarm time is set, move the Alarm switch to the 'AL1', 'AL2' or
'AL1+AL2' position. Set the Function switch to 'Alarm'. The AL1 or AL2
indicator (or both, if dual alarm has been chosen) will light and the alarm
tone(s) will then sound at the preset time.
To turn off the alarm immediately, either press the Time/Alarm off button,
in which case the alarm will operate again 24 hours later, or slide the
Function switch to 'Off' position to switch off the alarm function.
Note: The 'AL1' and 'AL2' buzzer tones are different for easy recognition.
Wake to radio
Set the Alarm switch to the 'AL1', 'AL2' or 'AL1+AL2' position. Set the
Function switch to 'Auto'. The AL1 or AL2 indicator (or both, if dual alarm
has been chosen) will light and the radio will then operate at the preset
time.
Note: Ensure that the Volume control is set at an adequate level to
wake you up. If not manually switched off, the radio and the
alarm tone will automatically switch off after 59 minutes.
If an alarm time has not been set and the Function switch is left in the
'Buzz' or 'Auto' position, the alarm/radio will operate at 12.00 midnight.
If you do not require the alarm function, ensure that the Function switch
is correctly set to the 'Off' position. The display alarm indicators will be
switched off.
Snooze Function
Alternatively, when the radio or buzzer alarms can be silenced for
approximately 7 minutes by pressing the Snooze button, after which time
the alarm will switch on again. This can be repeated within the 59 minute
alarm on time.
Note: If dual alarm has been chosen, the second wake function
will operate despite the use of the SNOOZE button.
Sleep Function
Your CR980 digital clock radio can be set to operate the radio and switch
off automatically after a preset period, adjustable up to 59 minutes. To set
the sleep function, switch the Function switch to 'Off, 'Auto' or 'Alarm'
depending on whether or not you require the alarm function the following
day.
Press the Sleep button briefly and observe that the display indicates the
preset time (59 minutes).
Hold the Sleep button depressed - the clock display will then automati-
cally count down from 59 minutes to one minute. Release the button when
the desired sleep time is displayed.
Set the Tuning and Volume controls as required.
To cancel the sleep function before the preset time has elapsed, press the
Time/Alarm off button once. The radio will switch off.
Auto Dimmer
The Auto Dimmer located on the top left side of the LED display will
automatically adjust the intensity of the clock display to suit room
brightness.
CR980 Instruction Book.pm6 24/10/99, 13:426