Filter
Top Products
16
Using the remote control
Battery Installation
1. Open the battery compartment door.
2. Insert 2 AAA-size batteries as indicated on the
back of the remote control.
3. Close the battery compartment door.
General Controls
The remote control’s buttons have the same
functions as the corresponding buttons on the
system unless listed and explained below:
TAPE – Press to activate tape mode. On logic deck
systems, it toggles between deck 1 and 2 (for Logic
Deck version only).
EQ PRESET – Press to scroll through the preset EQs:
pop, jazz, rock, custom (not available on RP-9328) or
flat.
VOL‹, › – Use to control the volume for all functions.
MUTE – Press once to reduce the volume to its
minimum level; press again to hear volume at
previous setting.
PLAY REV – Press to change/play the opposite tape
side.
PLAY FWD – Press to begin play of CD or tape.
PAUSE – Press once to temporarily suspend CD or
tape activity. Press again to resume activity.
TRACK REV – In CD mode, press once to search
backward through all the tracks or hold to scan back
through the current track. In tape mode, press to
rewind toward the beginning of the tape.
TRACK FWD – In CD mode, press once to search
forward through all the tracks or hold to scan
forward through the current track. In tape mode,
press to fast forward toward the end of the tape.
DISC SKIP – DISC CHANGE
SEEK – This button is only active in the Tuner mode.
Press once and the system will stop tuning on the
next available FM frequency.
In Your Sights
The remote control works by line-of-sight, which means that
for best results, you should aim the remote directly at the
front of the unit.
POWER
VIDEO 1•2
TAPECD
TUNING
SEEK
PRESET
TUNER
SHUFFLE
DISC SKIP
REPEA
T
PLAY REV
PAUSE
PLAY FWD
M
U
T
E
E
Q
P
R
E
S
E
T
V
O
L
V
O
L
TRACK REV
STOP
TRACK FWD
RECORD
SRS