Filter
Top Products
No sound from
speakers
No sound from one
speaker
Very little bass and/
or imaging
Speaker wire not connected
Speaker selector on amplier
is not on
Balance control on receiver or
pre-amp is not centered
Speaker wire not securely
connected
Speakers are wired out of
phase
Make sure wire is connected
at both the speaker and the
amplifier observing proper
polarity
Activate proper selector on
amplier
Place balance control in the
center
Check all connections at
amplier and speakers
Check entire system for
proper polarity and make ad-
justments as necessary
Frequency Response:
Sensitivity:
Power Handling:
Drive Units:
Impedance:
Finish:
Dimensions:
Weight:
Available Colors:
60 Hz - 20kHz
±
3 dB
87 dB (2.83V @ 1 Meter)
120 Watts
1) ” Mylar Dome Tweeter
1) 6” PolyGraphite Woofer
8 Ohms
ABS plastic
12”H x 7”W x 7”D
8 Lbs. with bracket
White and Black
Troubleshooting
Probable Cause: Solution:Situation:
Specications