Filter
Top Products
8
The Basics
9
The Basics
• If the product has been exposed to rain or water.
• If the product does not operate normally by following
the operating instructions, adjust only those controls
that are covered by the operating instructions.
Improper adjustment of other controls may result in
damage and will often require extensive work by a
qualifi ed technician to restore the product to normal
operation.
• If the product has been dropped or damaged in
any way.
• When the product exhibits a distinct change in
performance.
Replacement parts—When replacement parts are required,
be sure the service technician uses replacement parts
specifi ed by the manufacturer or has the same characteristics
as the original part. Unauthorized substitutions may result in
fi re, electric shock, or other hazards.
Safety Check—Upon completion of service or repairs to
this product, ask the service technician to perform safety
checks to determine that the product is in proper operating
condition.
Wall or Ceiling Mount—The product should be mounted to a
wall or ceiling only as recommended by the manufacturer.
Heat—The product should be situated away from heat
sources such as radiators, heat registers, stoves, or other
products (including amplifi ers) that produce heat.
Power Lines—Locate an outdoor antenna away from power
lines.
Non-use Periods—Unplug the product’s power cord when you will
not use it for extended periods.
before you begin
connect power
Plug the power cord into a standard AC outlet. All display
segments briefl y appear.
CAUTION: The power cord is equipped with a polarized plug
to prevent electric shock. One blade on the plug is wider than
the other and the plug only fi ts one way in the outlet. If you
cannot insert the plug easily, turn it over and try again. Do
not force it.
install a back-up battery
Your clock radio requires a 9V battery for back-up power (not
supplied, available at RadioShack or online at
www.radioshack.com).
• Dispose of old batteries promptly and properly. Do not
bury or burn them.
• Use only fresh batteries of the required size and
recommended type.
• Always remove an old or weak battery. Batteries can
leak chemicals that can damage electronic parts.
NOTE
1. Remove the battery
compartment cover.
2. Snap the battery onto
the connector.
3. Place the battery in
the compartment and
replace the cover.