Filter
Top Products
Preparation
7
PREPARATION
INSTALLING BATTERIES IN THE REMOTE
Your remote control requires two AAA batteries (not
supplied) for power. Batteries are available at your local
RadioShack store or online at www.radioshack.com.
1. Press the battery compartment
cover in the direction of the arrow
to slide it off.
2. Insert two AAA batteries into the
battery compartment according to
the polarity marks inside.
3. Replace the cover.
When the remote becomes inoperative,
replace the batteries. Ô
INSTALLING THE TRAVEL THEATER
In a Vehicle
1. Make sure the Travel Theater is securely fastened in
the carrying case.
2. Pull down the flap on the back of the carrying case and
reattach it, aligning the velcro strip to the panel.
3. Attach one of the supplied straps to the carrying case
and hang the strap over the back of the headrest.
4. Attach one strap to each loop on the bottom of each
side of the carrying case.
Ô NOTE Ô
• Make sure there is a clear path
between the remote and the
Travel Theater so the signal is
not blocked.
• Aim the remote at the Travel
Theater’s Remote Sensor when
you press any button on the
remote.
Ô BATTERY NOTES Ô
• Dispose of old batteries
promptly and properly.
• Do not burn or bury batteries.
• Use only fresh batteries of the
required size and
recommended type.
• Do not mix old and new
batteries, different types of
batteries (standard, alkaline, or
rechargeable), or rechargeable
batteries of different capacities.
• If you do not plan to use the
remote for a month or more,
remove the batteries. Batteries
can leak chemicals that can
damage electronic parts.