Filter
Top Products
6
Using Vehicle Battery Power
You can power the radio from a vehi-
cle’s 12V power source (such as ciga-
rette-lighter socket) using a 9V, 500 mA
DC adapter (not supplied) available at
your local RadioShack store.
Cautions:
You must use a power
source that supplies 9V DC
and delivers at least 500
mA. Its center tip must be set to
negative and its plug must fit the ra-
dio's
DC 9V
jack. Using an adapter
that does not meet these specifica-
tions could damage the radio or the
adapter.
• Always connect the DC adapter to
the radio before you connect it to the
power source. When you finish, dis-
connect the adapter from the power
source before you disconnect it from
the radio.
Follow these steps to connect DC pow-
er.
1. Be sure
POWER
is set to
OFF
, and
set
AC
/
DC
on the back of the radio
to
DC
.
2. Set the adapter’s voltage switch to
9V.
3. Insert the adapter’s 5.5 mm outer
diameter/2.1 mm inner diameter
barrel plug into the
DC 9V
jack on
the back of the radio.
4. Plug the other end of the adapter
into the vehicle’s cigarette-lighter
socket.
Note:
If the radio does not operate when
you connect a DC adapter, unplug the
adapter from the cigarette-lighter socket
and clean any ashes or debris from the
socket.
!
Cigarette
Lighter
Socket
12-795.fm Page 6 Friday, July 16, 1999 7:11 AM