Filter
Top Products
8
Adjusting the Angle Between Enclosures (Splay)
The illustration shows the rear pin block of two enclosures
joined by the upper enclosure’s rear link arm.
Use the first pin location (closest to the end) on the link arm
for setting in normalized 2° increments. The left-side example
shows two enclosures linked for 8° of splay. The ball-lock pin
is inserted into the 8° position in the rear block while passing
through the “normal” pin hole in the link.
When the "+3" location is used, an additional 3° are added to
the "normalized" location. The right side example shows two
enclosures linked for 9° of splay. The ball-lock pin is inserted
into the 6° position in the rear block while passing through the
“+3°” pin hole in the link. The total splay is the 6° indicated on
the block, plus the 3° additional from the link position, for a
total of 9°. In this manner 1° increments can be attained start-
ing with 3° (0° block location and +3° link arm location).
Fly Grid and Stacking Frame
There are two array frames available for the WideLine system.
The Fly Grid is used for suspending larger arrays. The Fly Grid
may be inverted and used for ground stacking.
The Stacking Frame is a compact and easier to handle frame
for use as a small array or stacking frame. This frame will eas-
ily sit on ground deck stacked bass enclosures or it can be
used at those smaller events to suspend clusters from the
stage trusses.
Fly Grid
Use only 5/16 inch diameter x 1.25 inch long ball-
lock pins on front receiver tubes.
The three pick up rails allow for any number of rigging solu-
tions to fit the most demanding venues. The rails are drilled
for industry standard 5/8 inch shackles.
Do not stack more than eight (8) enclosures on the
Fly Grid Large Array Frame.
Rear link
attached to
achieve an
8° splay
between
enclosures.
Rear link
attached to
achieve a 9°
splay
between
enclosures.
Left pickup rail
Center pickup rail
Right pickup rail
Front
Open end for bolt access
Bolt-on receiver
tube and 5/16 inch
diameter, 1.25 inch
long ball-lock pin
31.6” (803mm)
37.0”
(940mm)
14.8”
(376mm)