Filter
Top Products
Hardware
•
Two independent channels of DSP
•
48 kHz, 24-bit converters
•
No turn-on pops or zipper noise
•
If the memory or hardware fails,unit turns on muted
•
Host interface via RS-232 or QSControl Audio Network System*
via CM16a Amplifier Network Monitor
•
Electronically balanced inputs
•
Contact closure to trigger preset changes
•
Post-DSP output signal for daisy-chaining
•
Peak, RMS and Clip meter displays
•
DataPort “pass-through”compatible with QSControl
•
Selectable input sensitivity: 1.5, 4, 9, 18 Vrms;
6, 14.5, 21.5, 27.5 dBu; 3.5,12,19,25 dBV
Software
•
“Drag-and-drop”configuration software
•
DSP processing power and memory dynamically assignable to
signal processing functions
•
Graphical representation of DSP resources
•
Firmware upgrades downloadable via RS-232
•
Hard copy printout of configuration description and parameter settings
ADDITIONAL FEATURES
•
Multiple Parametric Filters,assignable anywhere in the signal chain:
Variable Frequency Bypass all EQs
Variable Gain Add EQ
Variable Q Delete EQ
Apply Bypass Show Response
•
Multiple Delays, assignable anywhere in the signal chain
20.83 µsec Incremental
910 msec Maximum
•
Dynamics Processor with Compressor and Expander,assignable
anywhere in the signal chain:
Gain Release Time
Threshold Show Response
Ratio Bypass
Attack Time
•
Output Peak Limiter, assignable anywhere in the signal chain:
Gain Release Time
Threshold Show Response
Attack Time Bypass
•
High and Low-Pass Crossover Filters, assignable anywhere in the
signal chain:
Butterworth 6, 12, 18,24 dB per octave slope
Bessel 6, 12, 18, 24 dB per octave slope
Linkwitz-Riley 12 and 24 dB per octave slope
Apply Bypass Delete EQ
Bypass all EQs Show Response
Add EQ
•
High and Low-Pass Shelf Filter,assignable anywhere in the signal chain:
Variable Corner Frequency Bypass all EQs
Variable Gain Add EQ
Variable Q Delete EQ
Apply Bypass Show Response
•
Signal Mute
•
Attenuation: 0.1 dB steps
•
Mix Post Crossover Audio (2
➜
1 Mixer)
•
Signal Splitter
•
Built-in Noise Generator (Pink & White)
•
Built-in Variable Frequency Tone Generator
•
Signal Polarity Reversal
•
Frequency Response readout after each filter
•
Clip and Protect Indication at any point in the signal chain
SIGNAL PROCESSING FUNCTIONS
* Available in early 2001.