Filter
Top Products
7
1. Slide the Combination dead bolts to unlock position.
2. Press the Open buttons to detach the speakers from the main base.
Using the Aux-in Jack
1. Press and hold the Play/Pause on the main base or press the Power on button on
remote control to turn on the main base,
the power on indicator will turns on with red color if
there is no an iPod or iPhone docked on the main base.
Note: the power on indicator turns to red color means the docking station is in AUX-IN mode.
2.Connect an audio cable to the headphone or line-out jack of an audio device and
plug the other end into the Aux -in jack located on back of the main base
3.Turn audio device on and play this device.
4.
Rotary the volume knob to choose a proper volume level, When
finished, press and hold the Play/Pause on the main base or press the Power on
button on remote control to turn off the main base. Remember to turn off the speakers
and your audio device, too.
VIDEO OUT FROM THE iPod/iPhone
1. You can connect this unit to a television or other video display that has a composite video input.
2. Securely dock your iPhone or iPod with video.
3. Connect one end of an RCA cable (not included) to rear RCA video jack on the unit.
4. Connect the other end of the RCA cable to VIDEO IN of television or video display.
5. Press the FUNCTION button to select iPod/iPhone mode.
6. Select a movie from your iPod/iPhone menu.
7. iPod: On the main menu choose video then select video setting.
8. iPod: Make sure the TV Out section is set to "ON".
9. iPod: Switch back to the movie library and play the movie of your choice
Note: Video out will automatic when using an iPod touch or iPhone
8
TROUBLESHOOTING GUIDE
Should you experience difficulties in the use of this player, please refer to the following chart.
Symptom Possible problem Solution
AC adaptor is not plugged into
a wall outlet or the connector is
not plugged into the DC jack on
the back of the unit.
Plug the AC adaptor into a wall outlet and
plug the connector into the DC jack on the
unit.
Wall outlet is not functioning.
Plug another device into the same outlet to
confirm the outlet is working.
The base does not
switch on (no power)
Using no/wrong iPod cradle.
Make sure the dock cradle is the proper fit
for your iPod.
iPod/iPhone is not installed
properly.
Remove your iPod/iPhone from the dock
and check for any obstruction on the
connectors in the docking and on your iPod.
Then reseat it in the dock.
iPod/iPhone does not
respond to the speaker
system
Your iPod/iPhone is locked up.
Please make sure that your iPod/iPhone is
working properly before docking into the
unit.
iPod/iPhone is not installed
properly.
Remove your iPod/iPhone from the dock
and check for any obstruction on the
connectors in the docking and on your iPod.
Then reseat it in the dock.
iPod/iPhone does not
charge up
iPod/iPhone battery has
problem.
Please make sure your iPod/iPhone is
working properly before docking into the
unit.
Speakers do not play
the sound from docked
device
Speakers receive signal from
other devices, or the other set
of MW-1025A
Place the unit to a location where receive
lesser external signal.
Sound is cut off or
noisy
The unit experiences
interference
Do not turn on other wireless devices
simultaneously.
Sound source is distorted.
If the source is iPod/iPhone, try to check the
sound at personal computer before putting
into the iPod/iPhone. If you are using an
external sound source like digital audio
player, try reducing the output volume on the
device itself.
Sound is distorted
Volume level is set too high. Decrease the volume.