Filter
Top Products
4
WIRING
Fuse must be
installed within
18" of battery
Drill a hole in the firewall
and use a rubber grommet
to keep wire from shorting.
Mount the DAC-348 near
the front of the vehicle to
minimize signal path lengths
Run the cables under the
carpet near the side of the
vehicle. Be careful not to
drill or screw into the wires
when you replace the trim.
For systems over 300 watts,
add a ground cable from the
amp to the battery.
Run signal cables (RCAs)
and remote turn-on lead
down the opposite side of
the vehicle from the power
wire to avoid radiated noise.
Attach Ground Wires
firmly to solid metal.
Avoid sharp edges that
could chafe through the
insulation.
Positive
Battery
Terminal
Factory Ground wire may
need to be replaced if it is
frayed or broken.
Power distribution block.
eject
VOLUME
BASS
TREBLE
RIGHT
LEFT
BALANCE
TRACK
REVERSE
FOWARD
1
2
3
4
876
5
PPI
MARKET
ING DPT
Trk 1
NOTE
Before beginning, disconnect the negative (-) terminal of the
battery prior to working on the positive (+) terminal to prevent
a short to ground. This is important, unless you want to spend
the rest of your life with a nickname like
"Sparky,"
or
"Smokey."
Reconnect the negative terminal only after all connections have
been made.
BACK TO CONTENTS