Filter
Top Products
System Connections
Connecting to Audio/Video Sources
Move the switch “AV IN/OUT” to “IN” position on the right panel to put the unit into
audio/video input mode.
Use the audio cable to connect the AUDIO socket of your DVD player with the audio
output socket of external AV signal source.
Put one plug of the video cable into the VIDEO socket at the player’s side. Put the
other plug into the video output socket of external AV signal source.
Connecting to Power Adapter
The player is supplied with a switching power adapter. Connections should be made as
follows:
• Connect the rabbit joint end of the AC adapter to the power cord. Connect the AC
adapter to the side of the DVD player in the slot marked “DC+12V”. Plug the power
cord into an electrical socket. See the below figure:
13