Filter
Top Products
Additional information09
24
En
Resetting the system
Use this procedure to reset all system settings
to the factory default.
• When performing reset, first disconnect all
components connected to this unit.
1 Switch the unit on.
2 Press and hold
VOLUME –
on the top
panel, and
then press and hold
STANDBY/
ON
for three seconds.
Power is set to standby mode.
The next time you switch on, all the system
settings
should be reset.
About iPod/iPhone
“Made for iPod” and “Made for iPhone” mean
that an electronic accessory has been
designed to connect specifically to iPod or
iPhone, respectively, and has been certified by
the developer to meet Apple performance
standards. Apple is not responsible for the
operation of this device or its compliance with
safety and regulatory standards.
iPod and iPhone are trademarks of Apple Inc.,
registered in the U.S. and other countries.
The Bluetooth wireless
technology device cannot be
connected or operated. Sound
from the Bluetooth wireless
technology device is not
emitted or the sound is
interrupted.
• Check that no object that emits electromagnetic waves in the 2.4
GHz band (microwave oven, wireless LAN device or Bluetooth
wireless technology apparatus) is near the unit. If such an object is
near the unit, set the unit far from it. Or, stop using the object
emitting the electromagnetic waves.
• Check that the Bluetooth wireless technology device is not too far
from the unit and that obstructions are not set between the Bluetooth
wireless technology device and the unit. Set the Bluetooth wireless
technology device and the unit so that the distance between them is
less than about 10 m (32 ft.) and no obstructions exist between them.
• Check that the Bluetooth ADAPTER and the ADAPTER PORT of the
unit are correctly connected.
• The Bluetooth wireless technology device may not be set to the
communication mode supporting the Bluetooth wireless technology.
Check the setting of the Bluetooth wireless technology device.
• Check that pairing is correct. The pairing setting was deleted from
this unit or the
Bluetooth
wireless technology device. Reset the pairing.
• Check that the profile is correct. Use a Bluetooth wireless
technology device that supports A2DP profile and AVRCP profile.
Problem Remedy
XW-NAS5_CUXJ.book 24 ページ ２０１０年６月３日 木曜日 午後２時１８分