Pioneer IDK-01 MP3 Docking Station User Manual


 
Before you start 01
5
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Chapter 1
Before you start
Checking what’s in the box
Please check that you've received the following
supplied accessories:
Remote control
Lithium battery (CR2025)
iPod type adapter x6
AC adapter
Audio cable (2 m / 6.6 ft.) red/white
Video cable (2 m / 6.6 ft.) yellow
SR cable (2 m / 6.6 ft.)
These operating instructions
Warranty card (Japan / North America)
Inserting the battery
Reseat the lithium battery (CR2025) in the
remote control as shown right. When you
notice a decrease in the operating range,
replace the battery in the same manner.
1 Push the release tab to the right to
open the battery casing.
2 Pull out the battery casing.
3 Remove the battery from the casing.
If you're doing this for the first time, remove the
protective seal from the battery supplied with
the system before re-inserting it.
4 Place a new battery in the casing.
Make sure the side of the battery is facing up
when you place it in the space provided.
Caution
When using lithium batteries, please observe
the following:
Dispose of used battery cells immediately
after replacement. Keep away from
children.
If swallowed, please contact a doctor
immediately.
Lithium batteries may present a fire or
chemical burn hazard if misused. Do not
disassemble, heat above 100°C (212°F), or
incinerate.
Remove the battery if the unit isn’t going to
be used for a month or more.
When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction’s rules
that apply in your country or area.
There is danger of explosion if the battery is
incorrectly replaced. Make sure to replace
only with the same type recommended by
the manufacturer.
Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.
Cleaning the unit
Use a polishing cloth or dry cloth to wipe
off dust and dirt.
When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted
five or six times with water, and wrung out
well, and then wipe again with a dry cloth. Do
not use furniture wax or cleansers.
Never use thinners, benzine, insecticide
sprays or other chemicals on or near this
unit, since these will corrode the surface.
1
2
4
3
IDK-01.book Page 5 Friday, August 4, 2006 9:54 AM