Filter
Top Products
Connecting the Loudspeakers
PIEGA AP 3, AS 3
Instructions for connecting the loudspeakers...
9
The loudspeaker is provided with the terminal for single wiring applications. This is used for connecting standard loudspeaker cables
with banana plugs. Ideally however, PIEGA AP3, AS 3 loudspeakers are connected with the OPUS 3 loudspeaker cable which was
specially developed for PIEGA loudspeakers with ribbon tweeters, and is available as an accessory from specialist dealers.
Connection:
>Ensure that the electronic components are switched off before making
the connection
>The AP 3, AS 3 loudspeakers must only be connected to electronic
components with the amplier outputs recommended by PIEGA
>Ensure without fail the recommended amplier output of 20 - 200 W
(4 Ohm) - If you are not sure that the connection is correct, contact
your specialist dealer
>The loudspeakers have an impedance of 4 Ohms and can therefore
be connected to any standard amplier - Contact your specialist dealer
concerning this
>Connect the PIEGA AP 3, AS 3 cables to your amplier or receiver
as shown in the gure. Ideally, use the OPUS 3 loudspeaker cable
(optional) with banana plugs or standard loudspeaker cables with a lead
Active variant:
>For AP 3, AS 3 loudspeakers with the active module option, refer to the
separate user manual
Hinweis:
8 or 16 Ohm ampliers supply at 4 Ohms twice or four times
the output, which considerably improves the output characteristics...!