Philips SA4RGA08 MP3 Player User Manual


 
30 EN
11 Technical data
Power
 Power supply: 220 mAh Li-ion polymer
internal rechargeable battery
 Play time¹
Audio (.mp3): up to 15 hours
Software
 
and transfer music
Connectivity
 Headphone 3.5 mm
 USB 2.0 High speed
Sound
 Channel separation: 45 dB
 Frequency Response: 20-18,000 Hz
 Output power: 2 x 2.4 mW
 Signal to noise ratio: > 84 dB
Audio playback
Supported formats:
 MP3
Bitrate: 8-320 kbps and VBR
Sampling rates: 8, 11.025, 16, 22.050,
32, 44.1, 48 kHz
 WMA (unprotected)
Bitrate: 10-320 kbps CBR, 32-192 kbps
VBR
Sampling rates: 8, 11.025, 16, 22.050,
32, 44.1, 48 kHz
 WAV
Storage media
Built-in memory capacity²:
 SA4RGA02 2 GB NAND Flash
 SA4RGA04 4 GB NAND Flash
 SA4RGA08 8 GB NAND Flash
Media transfer³
 Songbird (sync)
 Windows Explorer (drag and drop)
Display
 Color LCD 128 x 64 pixels
Note

¹ Rechargeable batteries have a limited number of
charge cycles. Battery life and number of charge cycles
vary by use and settings.
² 1 GB = 1 billion bytes; available storage capacity is
less. Full memory capacity may not be available as some
memory is reserved for the player. Storage capacity
is based on 4 minutes per song and 128-kbps MP3
encoding.
³ Transfer speed depends on operating system and

PC requirements
 Windows® XP (SP3 or above) / Vista / 7
 Pentium III 800 MHz processor or higher
 512 MB RAM
 500 MB hard disk space
 Internet connection
 Windows® Internet Explorer 6.0 or later
 CD-ROM drive
 USB port