Filter
Top Products
IN-CAR CONNECTION
12
Only use the AY 3545 car
voltage converter (4.5 V, DC,
positive pole to the center
pin) and the AY 3501 car
cassette adapter. Any other
product may damage the set.
1 Put the CD player on a
horizontal, vibration-free and
stable surface. Make sure it
is a safe place, where the
player is not a danger or
obstacle to the driver and passengers.
2 Insert the voltage converter into the cigarette lighter socket. If necessary, clean
the cigarette lighter socket to obtain a good electrical contact. (only for a 12 V
car battery, negative grounding).
3 Connect the DC plug of the voltage converter to the 4.5V DC socket of the CD
player.
4 Turn down the volume and connect the cassette adapter plug to the LINE OUT / p
of the CD player.
5 Carefully insert the cassette adapter into the car radio’s cassette compartment.
6 Make sure the cord does not hinder your driving.
7 Start the CD player, set VOL E to position 8 and adjust the sound with the car
radio controls.
• Always remove the voltage converter from the cigarette lighter jack when the CD
player is not in use.
Notes: – Avoid excessive heat from the car heating or from direct sunlight (e.g. in a
parked car in the summer).
– If your car radio has a LINE IN jack, use the LINE IN jack for the car radio
connection instead of the cassette adapter. Connect the signal lead to this
LINE IN jack and the LINE OUT / p jack of the CD player.
D
I
G
I
T
A
L
D
I
G
I
T
A
L
D
IG
I
TA
L
4.5 V DC
12 V DC
In-car use (connections supplied or optionally available)
English
EXP201/17 eng 27/7/01 15:23 Page 12