Philips DVP620VR MP3 Player User Manual


 
There are many ways to connect your new DVD/VCR to your Television and other equipment.This Quick-Use
Guide shows the easiest, most common connection.
Higher quality connections are explained in the accompanying owner’s manual and will provide better sound or
picture if your TV and/or audio system is compatible.
SCART IN
RF OUT
AERIAL
DVD
DVD/VCR
AV1(TV)
VCR
AV2(DECODER)
ANALOG
AUDIOOUT
DIGITAL
AUDIO OUT
S-VIDEO
OUT
COAXIAL
L
R
OPTICAL
RF COAXIAL CABLE
OR
2
ANTENNA or
CABLE TV SIGNAL
3
4
SCART IN
IN
OUT
CABLE BOX
(Optional)
ANTENNA or
CABLE TV SIGNAL
1
Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only after you
have finished hooking up everything. Never make or change connections with equipment connected to the power outlet.
2
Connect your existing RF cable from the Antenna TV signal directly to the AERIAL jack on the rear of the
DVD/VCR using an RF cable (not supplied). If you have a Cable Box (or Satellite Receiver), connect the OUT jack of
the Cable Box/Satellite Receiver to the AERIAL jack on the DVD/VCR using an RF coaxial cable (not supplied).
3
Connect the supplied black RF coaxial cable to the DVD/VCR’s ANT-OUT jack and to your TV’s ANTENNA
IN jack. The TV’s ANTENNA IN jack may be labelled 75-ohm,TV IN, or RF IN. Check your TV manual for details.
4
Plug the power cords of the DVD/VCR,TV and Cable Box (if applicable) to a power outlet.
5
Turn on the TV power. Set the TV to a video channel. (See the accompanying DVD/VCR owner’s manual for
details.)
6
Press the STANDBY-ON 2 button on the DVD/VCR or its remote to turn on the DVD/VCR. The first
time you turn on the DVD/VCR, you should complete the VCR setup. See the other side of this Quick-Use Guide for
details.
D
VP620VR
-
-
DVP620VR_00-Eng_rev2 10/1/04 16:48 Page 1