Filter
Top Products
9
Set the POWER control to the desired sound source:
CD, TUNER, or TAPE.
The set is switched off when the POWER control is set to
OOFFFF/TAPE and the keys of the tape deck are released.
Note: If you use batteries, always be sure to switch the set off
after use. This will avoid unnecessary power consumption.
Adjust the volume using the VOLUME control.
™ Display indication: Volume level from 0 to 32 (AZ 1205 only).
Increase and decrease the bass level by pressing DBB.
The bass level can also be emphasized if you place the set against
a wall or shelf. Do not cover any vents; leave sufficient room
around the unit for ventilation.
1 Set the POWER control to TUNER.
2 Select the wave band using the BAND selector.
3 Tune to the desired radio station by using the TUNING knob.
Improving RADIO reception
For FM stations, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the signal
is too strong (very close to a transmitter).
For AM stations, direct the built-in antenna by turning the whole
set. The telescopic antenna is not needed.
BAND
TUNING
FM
MW
LW
1600
275
255
1300
kHz kHz
MHz
1000
800
225
200
630
530
155
175
LW MW FM
88
92
96
100
104
108
OPEN
Radio – tuning to radio stations
VOLUME
DYNAMIC
BASS
BOOST
DBB
TUNER
TAPE
CD
VOLUME
DYNAMIC
BASS
BOOST
DBB
TUNER
TAPE
CD
AZ 1200
AZ 1201
AZ 1205
Adjusting volume and sound
CD SYNCHRO START REC
O
VOLUME
DYNAMIC
BASS
BOOST
DBB
TUNER
TAPE
CD
Switching the set on and off
English
BASIC FUNCTIONS RADIO