Filter
Top Products
English
5
MAINS SUPPLY AND DEMO MODE
1. Check if the power voltage, shown on the type plate on the
bottom of the set, corresponds to your local mains supply. If
it does not, consult your dealer or service centre.
2. Connect the mains plug into the wall socket. The mains
supply is now switched on and the display will show the
PHILIPS demo mode.
™ PH..IL ..IPS scrolls across the display continuously.
• Turn the SET control to SET TIME to exit the demo mode.
3. To disconnect the set completely from the mains supply,
withdraw the mains plug from the wall socket.
POWER BACK-UP
The power back-up conveniently allows your preset stations,
alarm and clock time settings to be stored for up to 3 minutes
when there is a power interruption e.g. AC mains failure.
The complete clock radio and display illumination will be
switched off. As soon as the mains supply returns, the display
will indicate the correct time.
If mains supply returns after 3 minutes and the display shows:
• clock time blinking– indicates you need to re-adjust the
clock time
• PHILIPS demo mode– indicates you need to re-enter preset
stations and the clock and alarm times.
ILLUMINATION BRIGHTNESS
1. Check if the SET control is turned to CLOCK position and the
radio is switched off.
2. Press REPEAT ALARM/
BRIGHTNESS CONTROL once or more.
– The brightness of the display will change in this
sequence:
BRIGHT y MEDIUM y LOW y BRIGHT...
Note:
when an alarm or the SLEEP function is active, brightness
cannot be adjusted.
RESET
Should the display and electronic functions of your set receive
interference e.g. static electricity from carpets, thunderstorms,
etc. RESET allows you to clear all previous settings and start
up again.
• Use a ballpoint pen to press the RESET hole found on the
bottom of the set.
INSTALLATION BASIC FEATURES
XP AJ 3430/00 29-03-2000 16:21 Pagina 5