Filter
Top Products
RADIO
You can use this set solely as a radio!
1
Adjust
RADIO
ON
/
OFF to ON to switch on the radio.
2
Select your waveband by adjusting the BAND switch
.
3
Adjust TUNING to tune to your desired station
.
4
Turn the VOL control to adjust the volume level
.
5
Adjust
RADIO
ON
/
OFF to OFF to switch off the radio.
To improve reception:
FM: extend and
position the pigtail for optimum reception
.
AM:
uses a built-in aerial inside the set. Direct the aerial by adjusting the
position of your set
.
SETTING THE CLOCK AND ALARM TIMES
The time is displayed using the 24-hour clock
IMPORTANT!
To adjust the clock and alarm times accurately, always make sure
you press the
7
or
∞
buttons separately and not simultaneously.
1
Adjust the clock control to SET TIME or
SET
AL. 1 or
SET
AL. 2 to set the
clock or alarm time respectively.
2
Press
7
or
∞
repeatedly or hold down on the respective button to adjust the
hours and minutes.
3
Release
7
or
∞
when you reach the correct setting.
4
After you have set both the hour and minutes, adjust the clock control to
CLOCK to run on clock time.
SELECTING THE ALARM MODE
GENERAL
If you wish to use the alarm, you must first set the alarm time first. You can choo-
se from two different alarm modes to wake you up: by radio or buzzer.
•
Select your choice of alarm mode by adjusting ALARM 1 or ALARM 2 to
RADIO or BUZ.
™
The 2 buzzers are at a set volume and cannot be adjusted. BUZ on
ALARM 1 is a low tone buzzer while BUZ on ALARM 2 is a high tone.