Filter
Top Products
PREPARATIONS
Power supply
Using the AC / DC adaptor
Turn off the player before connecting the
supplied adapter to it and the main power
supply (as shown). The player must be
turned off when the battery charges.
TIP
To avoid damage to the player, switch off before plugging or unplugging the
AC adaptor.
Using the car adapter
Connect the supplied car adapter to the set and the car cigarette lighter outlet.
TIP
• To avoid damage to the player, switch off before plugging or unplugging
the car adaptor.
• When connecting with car power (cigarette lighter) adaptor, be sure the
input voltage of the adaptor is identical with car voltage.
• Make sure the temperature is below 35
o
C when the DVD player is con-
nected to DC 16.0V in a car.
Powering your remote control
1 Open the battery compartment. Remove the protective
plastic tab (first time users only).
2 Insert 1 x lithium 3V battery, type CR2025, then close
the compartment.
✔
✔
CAUTION
- Batteries contain chemical substances, so they should be disposed of properly.
- Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
- Incorrect use of batteries can cause electrolyte leakage
and will corrode the compartment or cause the batteries to burst.
PREPARATIONS
- Remove the battery if the remote control is not to be used for a long time.
Connections
Connecting headphones
Connect the headphones into the p jack of
your set.
Connecting additional equipment
• Turn off your set before connecting to any addi-
tional equipment.
• You can connect the player to a TV or an amplifier
to enjoy DVDs or karaoke.
AV OUT
Connect the desired device to this terminal directly
(no setting needed in the DVD mode).
White
Red
Yellow
9
English
P01-17_Pet702_55_Eng 1/29/08 15:43 Page 9