Filter
Top Products
USING THE ALARM
GENERAL
Two different alarm times can be set. This can be useful when you need to be
woken up at a different time e.g. during the week and at the weekend:
• ALARM - radio mode
• ALARM - buzzer mode. The gentle wake buzzer alarm increases its beep tone
frequency within seconds.
SETTING THE ALARM TIME AND MODE
(See
3
)
1. Check the radio is switched off.
2. Press ALARM or ALARM to on.
™
Display: OFF
disappears under the respective
AL
or
AL
icon.
3. Press and
hold SET AL or SET AL until alarm time digits flash.
4.
Hold down or press HR + or MIN + repeatedly to set and adjust the hours
and minutes respectively. Release HR + or MIN + when you have reached
the correct setting.
5. After both the hours and minutes are set, press
SET AL or SET AL
to
confirm the setting.
Helpful hints:
–
If you have selected ALARM , make sure you have properly tuned to a
station before turning off the set.
–
If you set and activate the same time for both alarms, only the ALARM will be
activate at the set time.
–
When both ALARM and ALARM are turned on, by default the display
shows the alarm time nearest to activtion.
–
To check the alarm time setting for ALARM or ALARM , press ALARM or
ALARM button.
–
It is not possible to adjust the alarm time during an alarm call or the repeat alarm
mode.
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24-hour ALARM RESET will be automatically selected after 59
minutes from the time your alarm first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain
the same alarm setting for the following day:
•
Press
ALARM RESET / SLEEP
.
™
You will hear a beep tone confirming 24 hour reset activation.
REPEAT ALARM
This repeats your alarm call at 9 minute intervals.
•
During the alarm call, press REPEAT
ALARM /
BRIGHTNESSCONTROL..
™
Display shows
(
AL
)
or
(
AL
)
flashing during a repeat alarm.
•
Repeat if desired (up to a maximum of 6 times).
CANCELING THE ALARM COMPLETELY
•
Press
ALARM
or
ALARM
button once or more until the OFF appears
under the respective
(
AL
)
or
(
AL
)
icon.
SLEEP
(See
4
)
About Sleep
This set has a built-in sleep timer, which enables the radio to be automatically
switched off after a set period of time. There are four sleep time options.
Setting and switching off SLEEP
1 Within 1 second,
press
ALARM RESET / SLEEP
twice until the display shows
SLEEP and SL: 60
.
™
The radio is automatically switched on and tunes to the last station.
2 To select other sleep time options, press ALARM RESET / SLEEP
again within 1
second before the display returns to clock time.
™
The display shows in sequence: SL : 30, SL : 15 and OFF.
3
To cancel sleep, press either:
–
RADIO ON/OFF
– REPEAT
ALARM /
BRIGHTNESSCONTROL.
–
ALARM RESET / SLEEP
once or more until
SLEEP
disappears from the
display.
MAINTENANCE & SAFETY
•
Install the unit near the AC outlet and where the AC power plug can be easily
reached.
•
The apparatus shall not be exposed to dripping or splashing.
•
Do not expose the set to humidity, rain, sand or excessive heat caused by
heating equipment or direct sunlight.
•
To clean your set, use a soft damp cloth or chamois leather. Do not use clean-
ing products, which contain benzene, thinner, etc. as these may harm the
housing.
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock!
No sound
– Volume not adjusted
• Adjust the volume
Display error / no reaction to any controls
– Electrical malfunction
•
Press the RESET hole on the bottom of the set with a ball-pen.
Intermittent crackling sound during FM reception
– Weak signal
•
Extend and position the pigtail aerial
The alarm does not function
–
Alarm time/ mode not set
• See SETTING THE ALARM
– Volume too low for radio
• Increase the volume
– AL not tuned to a radio station
• Check if the set is tuned to a radio station before you set AL and when you
switch off the radio.
ENVIROMENTAL INFORMATION
All unnecessary packaging material has been omitted. The packaging can
be easily separated into three materials: cardboard, polystyrene and plas-
tic.
Your set consists of materials which can be recycled if disas-
sembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging, dead batteries
and old equipment.
Notes
Disposal of your old product
Your product is designed and manufactured with high quality materials
and components, which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a
product it means the product is covered by the European
Directive 2002/96/EC.
Please inform yourself about the local separate collection sys-
tem for electrical and electronic products.
Please act according to your local rules and do not dispose of your old
products with your normal household waste. The correct disposal of your
old product will help prevent potential negative consequences for the
environment and human health.
Notes
AJ100_05_Eng 2007.1.16 10:14 Page 2