Philips NP2500/37B Portable Multimedia Player User Manual


 
7
EN
Connect the player to a home network
Here is how to create a wireless connection to your home network with
broadband Internet access
The onscreen display guides you through the process of connecting the player. This
section describes the typical wireless setup with automatic IP address. For information
on different setups, consult the user manual.
Ensure that your network name and network password or encryption key are available.1
Turn on your wireless access point or wireless router with broadband Internet access.2
3 Follow the steps in section (B) and select [Ye s ], to create a connection to the network.
Select [4 Wireless (WiFi)] to start the network setup process.
For wireless routers with Wi-Fi protection system (WPS) that supports push
button configuration (PBC): On the router, press the WPS PBC push button (often
displayed as ) to activate. On NP2500 press OK to confirm.
For wireless routers with Wi-Fi protection system (WPS) that supports a personal
identification number (PIN): On NP2500 select WPS PIN, then enter the displayed
PIN on the router.
For other wireless routers:
NP2500 searches for networks. >
Select your network from the list of found networks and confirm.5
Enter the encryption key (if required) and confirm.6
(press CLEAR to delete last character entry /
press hold CLEAR to delete line entry)
The player >
acquires the automatic IP address;
shows the conrmation for the connection to the network;
shows the prompt for the connection to the Internet.
Select [7 Yes] to connect to the Internet.
The player shows the conrmation for the connection to the Internet. >
C
You can go to section Enjoy and listen to Internet radio at this point.
This icon indicates steps on your remote control!
np2500_qsg_01eng_37.indd 7 3/20/2009 5:12:14 PM