Filter
Top Products
EN 15
English
Note
Before pressing any function button on the remote •
control, fi rst select the correct source with the remote
control instead of the main unit.
If you are not going to use the remote control for a
•
long time, remove the battery.
Auto install radio stations
When you connect power and no radio
stations are stored, the DCM250 automatically
begins to store radio stations.
1 Connect the DCM250 to the power
supply.
[AUTO INSTALL - PRESS PLAY] (auto »
install - press the PLAY button) is
displayed.
2 Press on the main unit to start
installation.
The DCM250 automatically stores »
radio stations with suffi cient signal
strength.
When all the available radio stations »
are stored, the fi rst preset radio station
is broadcast automatically.
Set clock
1 In standby mode, press PROG to activate
the clock setting mode.
The 12 hour or 24 hour format is »
displayed.
2 Press / to select 12 hour or 24 hour
format.
3 Press PROG.
The hour digits are displayed and begin »
to blink.
4 Press / to set the hour.
5 Press PROG.
The minute digits are displayed and »
begin to blink.
6 Press / to set the minute.
7 Press PROG to confi rm.
Turn on
1 Press .
The DCM250 switches to the last »
selected source.
Switch to standby
1 Press to switch the DCM250 to
standby mode.
The backlight on the display panel is »
reduced.
The clock (if set) appears on the »
display panel.
To switch the DCM250 to Eco Power
Standby mode:
1 In standby mode, press and hold for
more than 2 seconds.
The backlight on the display panel »
turns off.