Filter
Top Products
1 Important
Safety
Important Safety Instructions
a Read these instructions.
b Keep these instructions.
c Heed all warnings.
d Follow all instructions.
e Do not use this apparatus near water.
f Clean only with dry cloth.
g Do not block any ventilation openings. Install in accordance with
the manufacturer’s instructions.
h Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifi ers) that
produce heat.
i Protect the power cord from being walked on or pinched, par-
ticularly at plugs, convenience receptacles, and the point where
they exit from the apparatus.
j Only use attachments/accessories specifi ed by the manufacturer.
k Use only with the cart, stand, tripod, bracket, or table specifi ed
by the manufacturer or sold with the apparatus. When a cart is
used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
l Unplug this apparatus during lightning storms or when unused
for long periods of time.
m Refer all servicing to qualifi ed service personnel. Servicing is
required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
n Battery usage CAUTION – To prevent battery leakage which
may result in bodily injury, property damage, or damage to the
unit:
Install all batteries correctly, + and - as marked on the unit.
•
Do not mix batteries (old and new or carbon and alkaline,
•
etc.).
Remove batteries when the unit is not used for a long time.
•
The batteries shall not be exposed to excessive heat such as
•
sunshine, fi re or the like.
o Apparatus shall not be exposed to dripping or splashing.
p Do not place any sources of danger on the apparatus (e.g. liquid
fi lled objects, lighted candles).
q This product may contain lead and mercury. Disposal of these
materials may be regulated due to environmental considerations.
For disposal or recycling information, please contact your local
authorities or the Electronic Industries Alliance: www.eiae.org.
r Where the MAINS plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily
operable.
Warning
Never remove the casing of this apparatus. •
Never lubricate any part of this apparatus. •
Never place this apparatus on other electrical equipment. •
Keep this apparatus away from direct sunlight, naked fl ames or heat. •
Ensure that you always have easy access to the power cord, plug or •
adaptor to disconnect the apparatus from the power.
Copyright in the U.K.
Recording and playback of material may require consent. See Copyright
Act 1956 and The Performers’s Protection Acts 1958 to 1972.
Notice
Any changes or modifi cations made to this device that are not expressly
approved by Philips Consumer Lifestyle may void the user’s authority to
operate the equipment.
This product complies with the radio interference requirements of the
European Community.
This product complies with the requirements of the following directives
and guidelines: 2004/108/EC + 2006/95/EC
Recycling
Your product is designed and manufactured with high quality materials
and components, which can be recycled and reused.
When you see the crossed-out wheel bin symbol attached to a product,
it means the product is covered by the European Directive 2002/96/EC:
Never dispose of your product with other household waste. Please
inform yourself about the local rules on the separate collection of elec-
trical and electronic products. The correct disposal of your old product
helps prevent potentially negative consequences on the environment
and human health.
Your product contains batteries covered by the European Directive
2006/66/EC, which cannot be disposed of with normal household
waste.
Please inform yourself about the local rules on separate collection of
batteries. The correct disposal of batteries helps prevent potentially
negative consequences on the environment and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to make the
packaging easy to separate into three materials: cardboard (box), poly-
styrene foam (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused if
disassembled by a specialized company. Please observe the local regula-
tions regarding the disposal of packaging materials, exhausted batteries
and old equipment.
Note
The type plate is located on the bottom of the apparatus. •
Register your product and get support at
www.philips.com/welcome
EN User manual
DC220
© 2010 Koninklijke Philips Electronics N.V.
All rights reserved.
DC220_05_UM_V1.1
2 Your Clock Radio for iPhone/iPod
Congratulations on your purchase, and welcome to Philips! To fully
benefi t from the support that Philips offers, register your product at
www.philips.com/welcome.
Introduction
With this unit, you can enjoy audio from the iPod, iPhone, other audio
devices, or the radio.
The radio, iPod, or iPhone can be set as the alarm timer. You can set two
alarm timers to go off at different time.
What’s in the box
Check and identify the contents of your package:
Main unit
•
1 x AC power adaptor•
1 x MP3 LINK cable•
User manual•
Quick start guide•
Overview of the main unit
Top View
a POWER
Turn on the unit or switch to standby mode.
•
Deactivate the sleep timer.•
Stop alarm.•
b DATE • AUTO TUNE / TIME SET
Set the date and clock.
•
Search and program radio stations automatically.•
c AL 1 / AL 2
Set the alarm timer.
•
Turn off the alarm tone.•
View alarm settings.•
REPEAT ALARM
BRIGHTNESS CONTROL
E
MULOV
TUNING
TUNING
SOURCE
SLEEP
AL
2
AL1
BBD
DOCK for
a b c d e
l jk i gh f
d /
Skip to the previous/next audio fi le.
•
Search within an audio fi le.•
Select a preset radio station.•
Adjust time.•
e TUNING +/-
Tune to a radio station.
•
Adjust time.•
f VOL +/-
Adjust volume.
•
g
Start or pause iPod/iPhone play.
•
h REPEAT ALARM/BRIGHTNESS CONTROL
Repeat the alarm.
•
Adjust the display brightness. •
i iPod/iPhone dock
Load an iPod/iPhone.
•
j DBB
Turn on or off dynamic bass enhancement.
•
k SLEEP
Set the sleep timer.
•
l SOURCE
Select a source: iPod/iPhone, FM tuner or AUX.
•
Back View
OPEN
MP3 LINK
FM AERIAL
9V DC IN
n
o
m
p
m Backup battery compartment
Insert 2 pieces of AAA/R03/UM4, 1.5V batteries.
•
n FM AERIAL
Improve FM reception.
•
o MP3-LINK
Jack for an external audio device.
•
p DC IN
Power supply socket.
•
3 Get started
Caution
Use of controls or adjustments or performance of procedures •
other than herein may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model and serial number
of this apparatus. The model number and serial number are on the bot-
tom of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Connect power
Caution
Risk of product damage! Ensure that the power voltage •
corresponds to the voltage printed on the back or underside of
the apparatus.
Ris
• k of electric shock! When you unplug the AC adaptor, always pull
the plug from the socket. Never pull the cord.
Befor
• e connecting the AC adaptor, ensure you have completed all
other connections.
1 Connect one end of the AC adaptor to the DC IN socket on the
main unit.
2 Connect the other end of the AC adaptor to the wall outlet.
Note
The voltage and power rating information is located on the bottom •
of the unit.
Set time and date
1 Dock the iPod/iPhone on the unit.
2 Open the iPod/iPhone.
Time and date information on the iPod/iPhone transfers to the
»
unit automatically.
To set time and date manually:
1 In standby mode, press and hold DATE • AUTO TUNE / TIME SET
for 2 seconds.
[24 HR] begins to blink.
»
2 Press TUNING +/- or
/ to select 12/24 hour format.
3 Press DATE • AUTO TUNE / TIME SET to confi rm.
The hour digits begin to blink.
»
4 Press TUNING +/- or
/ to set the hour.
5 Press DATE • AUTO TUNE / TIME SET to confi rm.
The minute digits begin to blink.
»
6 Repeat steps 4-5 to set the minute, year, month, and day.
Turn on
1 Press POWER .
The unit switches to the last selected source.
»
Switch to standby
1 Press POWER again to switch the unit to standby mode.
The time and date (if set) appear on the display panel.
»