Philips AZ 1145 Portable CD Player User Manual


 
13
AZ 1145/00 page 13
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this would
invalidate the guarantee.
PROBLEM
POSSIBLE CAUSE
REMEDY
No sound/power
VOLUME not adjusted
Adjust the VOLUME
Headphones connected
Disconnect headphones
Mains lead not securely connected
Connect the mains lead properly
Severe radio hum or noise
Electrical interference: set too close to TV,
VCR or computer
Increase the distance
Poor radio reception
Weak radio signal
FM: Direct the FM telescopic aerial for
optimum reception
MW/LW: Turn the set for optimum reception
or indication
No CD inserted
Insert a CD
CD badly scratched or dirty
Replace/ clean CD, see CD player and
CD handling
Laser lens steamed up
Wait until lens has cleared
indication
CD-R(W) is blank or the disc is not finalised
Use a finalised CD-R(W)
CD badly scratched or dirty
Replace/ clean CD, see CD player and
CD handling
The CD skips tracks
CD is damaged or dirty
Replace or clean the CD
SHUFFLE or a programme is active
Switch off SHUFFLE/PROGRAM
Poor cassette sound quality
Dust and dirt on the heads, etc.
Clean deck parts etc., see Maintenance
Use of incompatible cassette types (METAL
or CHROME)
Only use NORMAL (IEC I) for recording
Recording does not work
Cassette tab(s) may be broken
Apply a piece of adhesive tape over the
missing tab space
Remote control does not function properly
Batteries dead/ incorrectly inserted
Insert (fresh) batteries correctly
Distance/ angle between the set too large
Reduce the distance/ angle
This product complies with the radio interference requirements of the European Union.
The type plate is located on the bottom of the set.
English
XP AZ1145/00-1 08-05-2000 15:42 Pagina 13