Filter
Top Products
Basic functions
Switching on/off the set
1 To switch on,press POWER.
➜ Display lights up.The system will switch to
the last selected source.
2 To switch off,press POWER again.
➜ Display lights off.
Adjusting volume and sound
Adjust the sound with the VOLUME and
DBB controls.
Digital tuner
Tuning to radio stations
1 Press repeatedly SOURCE (or TUNER
on the remote control) to select FM or
MW.
➜ “TUNER” is displayed briefly, then the
radio station frequency, waveband and, if
programmed, a preset number are shown
(See 2).
2 Press and hold ∞ or § until the frequency in
the display starts running.
➜ The radio automatically tunes to a station
of sufficient reception. Display shows
“
SEARCH” during automatic tuning.
3 Repeat step 2 if necessary until you find the
desired station.
• To tune to a weak station, press ∞ or §
briefly and repeatedly until you have found
optimal reception.
To improve radio reception:
• For FM, extend, incline and turn the
telescopic aerial. Reduce its length if the signal
is too strong.
• For MW, the set uses a built-in aerial. Direct
this aerial by turning the whole set.
Programming radio stations
You can store 15 FM and 10 MW radio
stations in the memory manually or
automatically (Auto store).
Manual programming
1 Tune to your desired station (see Tuning to
radio stations).
2 Press PROG to activate programming.
➜ Display: PROG flashes.
3 Press ALBUM/PRESET +/-
(ALBUM/PRESET
3, 4
on the remote
control ) once or more to allocate a number
(from 1 to 25).
4 Press PROG to confirm.
5 Repeat steps 1-4 to store other stations.
Helpful hints:
– You can erase a preset station by storing
another frequency in its place.
Autostore
Autostore automatically starts programming
radio stations from preset 1.Any previous
presets e.g. manually programmed will be
erased.
1 Press repeatedly SOURCE (or TUNER
on the remote control) to select FM or
MW.
2 Press PROG until “AUTO” flashes.
➜ Available stations are programmed (MW
or FM).After all stations are stored, the
first autostore preset station will then
automatically play.
To listen to a preset or autostore
station
Press the ALBUM/PRESET +/-
(ALBUM/PRESET
3, 4
on the remote
control ) buttons once or more until the
desired preset station is displayed.
Basic Function/Radio MP3-CD/CD Player