Filter
Top Products
English
2 Replace the compartment door, making
sure the batteries are firmly and correctly
in place.The set is now ready to operate.
➜ If LOW BATT lights up, battery power
is running low.The LOW BATT indicator
eventually goes out if the batteries are
too weak.
Batteries contain chemical substances,
so they should be disposed of properly.
Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to
burst.Therefore:
• Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the same
type for the set.
• When inserting new batteries, do not try
to mix old batteries with the new ones.
• Remove the batteries if the set is not to be
used for a long time.
Using AC Power
1 Check if the mains voltage, as shown on
the type plate located on the
bottom of the set, corresponds to your
local power supply. If it does not, consult
your dealer or service center.
2 Connect the power cord to the MAINS
inlet and the wall outlet.The power supply
is now connected and ready for use.
3 To switch off completely, withdraw the
power cord from the wall outlet.
• Disconnect the power cord from the wall
outlet to protect your set during heavy
thunderstorms.
The type plate is located on the
bottom of the set.
Switching power on/off:
Save energy
Whether you are using mains or battery
supply, to avoid unnecessary energy
consumption always press the POWER
button to off after using the set.
• The set automatically switches off after 5
minutes in MP3-CD/CD stop mode.
• The display backlight only operates when
using AC power supply.
Standby power consumption..........................≤ 2 W
S
O
U
R
L
O
W
B
A
T
T
.
V
O
L
U
M
E
U
L
T
R
A
B
A
S
S
2
POWER
M
AC MAINS
10
AZ 1150 /17 page 10
Power Supply
AZ1150/17 eng 30/5/01 14:53 Page 10