Philips AJ7030D Clock Radio User Manual


 
Note
You can only use AC power as power supply. The pre-installed
lithium CR2032 battery can only back up time and alarm.
When power is disconnected, the display backlight is off.
For rst-time use:
Remove the protective tab to activate the battery.
To replace the battery: B
Connect power C
Caution
Risk of product damage! Ensure that the power voltage corresponds
to the voltage printed on the back or underside of the clock radio.
Risk of electric shock! When you unplug the AC adapter, always pull
the plug from the socket. Never pull the cord.
Set clock
1 In standby mode, press and hold SET for two seconds
to activate clock setting mode.
» [12H] or [ 24H] is displayed.
2 Press TUNING +/- or / repeatedly to select 12/24
hour format.
3 Press SET again to con rm.
The hour digits begin to blink. »
4 Repeat Steps 2 to 3 to set the hour and minute.