Philips AJ3916/05 Clock Radio User Manual


 
English
Clock/Alarm
Setting the Clock/Alarm time
1.
Press and hold MODE or ALARM 1/ ALARM 2 until clock digit for hour flashes.
2.
Press repeatedly, or hold down / § to adjust the hours.
3.
Press MODE or corresponding ALARM 1/ ALARM 2 to confirm the hour setting, and the
clock digits for minute flashes.
4.
Press repeatedly, or hold down / § to adjust the minutes.
5.
Press MODE or corresponding ALARM 1/ ALARM 2 to confirm the minute setting.
For ALARM only – Selecting the Alarm mode
6.
Press SOURCE repeatedly to select the desired alarm sound among Sound of nature, CD, Radio
or a buzzer.
3.Ways to switch off the alarm
To activate ‘Alarm Reset’ during the alarm call, press SLEEP.
To activate ‘Alarm Repeat’ during the alarm call, press REPEAT ALARM/BRIGHTNESS
CONTROL.
To deactivate the alarm completely, press once corresponding ALARM 1 or ALARM 2 untill
disappears.
CD playback
This CD clock radio supports audio discs including CD-R (CD-recordable), CD-RW (CD-rewritable).
1.
Press STANDBY-ON to switch on from clock mode.
2.
If CD is not selected, press SOURCE once or more to select it.
3.
Lift the CD door to open.
4.
Insert a CD with printed side facing up, and close the CD door.
5.
Press ); to start playback.
6.
To stop playback, press 9.
Radio
Autostore
1 Press repeatedly SOURCE to select FM or MW.
2 Press and hold PROG until the frequency in the display starts running.
Available stations are programmed (MW or FM). After all stations are stored.
To listen to a preset or autostore station
Press the PRESET +/- buttons once or more until the desired preset station is displayed.
Printed in China Jason-0809
AJ3916_05-QSG 2008.2.27 17:11 Page 2