Filter
Top Products
Using the alarm
AJ3915 allows you to simultaneously set two
different alarms (ALARM 1 and ALARM 2 )
which can go off in the CD, radio or buzzer
mode.The clock time needs to be set
correctly before using alarm.
Setting alarm time
1 Press and hold ALARM 1 or ALARM 2
until clock digit(s) for hour flashes.
➜ ALM1 or ALM2 is also displayed, flashing.
➜ It will exit the clock setting mode without
setting if there is 5-second inactivity.
2 Press repeatedly, or hold down ∞/ § to
adjust the hours.
3 Press corresponding ALARM 1 or
ALARM 2 to confirm the hour setting.
➜ The clock digits for minute flash.
4 Press repeatedly, or hold down ∞ / § to
adjust the minutes.
5 Press corresponding ALARM 1 or
ALARM 2 to confirm the setting.
• When CD•RADIO•BUZZER is pushed in
the CD position, selection of CD track
number will be also prompted. Press ∞ / §
to select desired track if you like.
• Repeat the steps above to set and activate
the other alarm if necessary.
➜ When alarm are/is set and activated.ALM1
and/or ALM2 are/is displayed.
Selecting alarm mode
1 Press POWER to switch to standby.
2 Select your choice of alarm mode: either CD
radio, or buzzer by using the
CD•RADIO•BUZZER slider.
➜ When alarm are/is activated,ALM1 and/or
ALM2 are/is displayed (See 6).
• At the set alarm time, the CD or radio or
buzzer will switch on automatically.
Notes:
– Insert a CD if you select CD source as
alarm mode. CD will play from the first
track, or the track you have selected during
the alarm setting. If a CD is not loaded,
buzzer will auto turn on.
– When AJ3915 is in AUX mode (connecting
an external device), only buzzer will turn on
at the set time regardless of the CD or
RADIO alarm mode you have selected.
– If you have an alarm set in the radio or CD
mode, make sure you have adjusted the
volume loud enough to wake you up.
Switching off the alarm
There are three ways of switching off the
alarm. Unless you choose to cancel the alarm
completely, the DAILY ALARM RESET option
will be automatically kept activated from the
time your alarm first goes off.
Daily alarm reset
If you want the alarm to be stopped
immediately but also wish to repeat the alarm
call at the same time for the following day:
1 During the alarm call, press once
corresponding ALARM 1 or ALARM 2,or
press POWER.
➜ The corresponding ALM1 or ALM2 is still
displayed.
Repeat alarm
This will repeat your alarm call at 6-minute
intervals.
1 During the alarm call, press
REPEAT ALARM as indicated by the arrow
located at the top panel.
➜ The corresponding ALM1 or ALM2 is still
displayed,yet flashing.
Switching off the alarm completely
Press once or more corresponding
ALARM 1 or ALARM 2 until ALM1 or
ALM2 disappears.
Alarm
AJ3915_05_CCR_ENG 2008.3.6 4:00 PM Page 9