Pelco c294m MP3 Player Accessories User Manual


  Open as PDF
of 4
 
Pelco Manual C294M (11/98) 3
To install the SWM Series wall mount (not supplied) to the pole adapter, perform
the following steps (see Figure 1):
1. Feed the electrical cables through the hole in the mounting cleat, and install
the cleat securely onto the adapter with two 1/4-20 socket head screws (sup-
plied). Position the cleat so the elongated mounting hole is below the cable
entry hole. Adjust the vertical alignment of the cleat before tightening the screws.
2. Feed the electrical cables through the mount, hook the mount onto the top of
the mounting cleat, and position the mount flush against the pole adapter.
Back out, if necessary, and tighten the set screw in the bottom of the mount
only until the mount is snug against the surface of the adapter. Do not over-
tighten
.
3. Attach the pendant dome back box to the mount:
a. Feed the electrical cables from the mount into the dome back box.
b. Apply anti-seize compound to the dome back box pipe threads.
c. Screw the dome back box into the threads in the mount.
d. Complete the installation following the instructions in the dome manual.
4.0 SPECIFICATIONS MECHANICAL
Construction: Aluminum
Finish
SWM-PA-GY: Gray polyester powder coat
SWM-PA-BK: Black polyester powder coat
Mount Method: Adapter is attached to a pole with two stainless steel
straps (supplied). Two stainless steel screws (supplied)
are used to attach the wall mount cleat (not supplied) to the
adapter. The lower hole in the mounting cleat is elongated,
which allows for vertical alignment adjustment.
Cable Entry: One cable feedthrough hole in the adapter and the mount-
ing cleat
Maximum Load: 10 lb (4.5 kg)
GENERAL
Environment: Indoor/outdoor
Dimensions: 5.00" H x 3.65" W x 1.50" D (12.70 x 9.27 x 3.81 cm)
Weight: Unit Shipping
0.7 lb (0.32 kg) 2.0 lb (0.91 kg)
(Design and product specifications subject to change without notice.)
3.2 SWM SERIES
SPECTRA
®
COMPACT
WALL MOUNT
NOTE:
Make sure no moisture
has condensed inside the mount
before installation.
NOTE:
The mounting cleat has
an arrow embossed in it, for orien-
tation purposes, and must point up-
ward.
NOTE:
Anti-seize compound is
supplied with the SWM Series wall
mount.
 previous