Filter
Top Products
4
3.0 INSTALLATION
The Patton Models 506 & 507 are simple to install and require no
user configuration. Follow these installation steps:
1) Be sure the metal D-sub connector on the device you are
protecting is connected to frame ground. If not, see step 4,
below.
2) Plug the DB-9 connector of the Model 506 or 507
directly
into
the DB-9 Serial port of the device you are protecting. Use of a
serial cable reduces the effectiveness of the protection you
would otherwise receive.
3) Plug your modular cable into the jack on the Model 506 or 507.
If you have a Model 506, the cable must be terminated with an
RJ-11 plug. If you have a Model 507, the cable must be
terminated with an RJ-45 plug.
4) To provide an alternate ground connection, use the short strap
supplied with the unit. Connect one loop to the device chassis
(or other chassis ground) and the other loop to the Model 506
or 507 as shown below.
Connect to
Chassis
Ground
Connect to
D-Sub
Screw
Figure 1. How to Connect the Patton Model DB-25 to Your PC, Modem or Printer
1.0 WARRANTY INFORMATION
Patton Electronics warrants all Model 506 & 507 components to
be free from defects, and will—at our option—repair or replace the
product should it fail within one year from the first date of shipment. This
warranty is limited to defects in workmanship or materials, and does not
cover customer damage, abuse or unauthorized modification. If this
product fails or does not perform as warranted, your sole recourse shall
be repair or replacement as described above. Under no condition shall
Patton Electronics be liable for any damages incurred by the use of
this product. These damages include, but are not limited to, the
following: lost profits, lost savings and incidental or consequential
damages arising from the use of or inability to use this product. Patton
Electronics specifically disclaims all other warranties, expressed or
implied, and the installation or use of this product shall be deemed an
acceptance of these terms by the user.
1.1 RADIO AND TV INTERFERENCE
The Model 506 & 507 Series units generate and use radio
frequency energy, and if not installed and used properly—that is, in strict
accordance with the manufacturer's instructions—may cause
interference to radio and television reception. They have been tested
and found to comply with the limits for a Class A computing device in
accordance with the specifications in Subpart J of Part 15 of FCC rules,
which are designed to provide reasonable protection from such
interference in a commercial installation. However, there is no
guarantee that interference will not occur in a particular installation. If
these products do cause interference to radio or television reception,
which can be determined by turning off the unit, the user is encouraged
to try to correct the interference by one or more of the following
measures: moving the computing equipment away from the receiver, re-
orienting the receiving antenna and/or plugging the receiving equipment
into a different AC outlet (such that the computing equipment and
receiver are on different branches).
1.2 CE NOTICE
The CE symbol on your Patton Electronics equipment indicates that
it is in compliance with the Electromagnetic Compatibility (EMC)
directive and the Low Voltage Directive (LVD) of the Union European
(EU). A Certificate of Compliance is available by contacting Technical
Support.
1