Filter
Top Products
7
Turn the unit on.
or or
LR
Using the FM radio (FM RADIO mode)
Setting mode
Other modes
Adjust the volume
Press and hold
Off
Press and hold
Press or (0-25)
Presetting stations (FM1, FM2)
AUTO
FM1: 20 stations can be stored. FM2: 10 stations can be stored.
MANUAL
3
Select manual or preset mode.
4
Select the station.
•
In the manual mode, press and hold until the frequency starts scrolling
to start automatic tuning. Tuning stops when a station is found.
• The tuning band steps can be changed (BAND STEP
→
page 8)
• FM1, FM2 : This needs to be
preset beforehand.
(
→
below “Presetting stations”
)
2
Select FM RADIO.
Skip this step if FM RADIO is already selected.
Press
UPDOWN
Press
Press Press
Select FM1
or FM2 by
step3.
Select FM1
or FM2 by
step3.
Select the
frequency.
Select the
channel.
PressPress Press Press
Exit the mode menu.
AUTO PRESET will
start. The radio
screen automatically
returns when AUTO
PRESET is finished.
Select .
To play the recording
Select MUSIC mode, then select
the FM RADIO play list. (
→
page 6)
While listening to the station.
Press
Press
Stop
Press .
Show available
time
Press .
Press again to show the recording time.
Recording the radio
Recording time
(Available time
→ Right)
Voice recording (IC RECORDER mode)
Microphone
Stop recording
Press .
Show
available time
Press .
Press again to show the recording time.
Off
Press and hold
1
4
Speak into the microphone.
3
Start recording.
2
Select IC RECORDER.
Skip this step if IC RECORDER is already selected.
Press
and hold
• Skip and Search method is the same as MUSIC mode.
• The unit will turn off if left in standby mode for more than 5 minutes.
FM1 FM2
Manual (No display)
To play
recorded
tracks
Press
After all recorded tracks are played the unit returns to standby
.
During play, press again to stop and return to standby.
or
Press Press
or
Press Press
Setting mode
Other modes
Press and hold
Available time
Do each step within 10 seconds
Do each step within 10 seconds
Press and
hold
Each time you press
Recording time
(Available time → below)
manual FM1 or FM2
The unit will highlight
the mode last used.
•
“NO TRACK PLAY”
appears on the display
if there is no wave file.
1,2
1,2,
4
3
Release
(before operation)
Release
(before
operation)
1
Turn the unit on.
Press
and hold
The unit will highlight
the mode last used.
Press
Repeat as many times as is required.
As the cord of the earphones
acts the FM antenna, extend
it as far as possible rather
than leaving it coiled.
3