14
RQT5189
Tips on Recording
Erasure prevention
The illustration shows how to remove the tabs to prevent recording.
To record on the tape again, cover as shown.
Erasing recordings
1 Insert the cassette with the side to be erased facing up.
2 Press [
n
TAPE/CD] to switch to TAPE mode.
3 Press [ / K].
A
B
Recording CDs
Normal recording
Preparation:
• Insert a CD (
\
page 10).
• Wind on the leader tape.
■
1
Press [0 DECK] to open the deck.
Load a cassette with the side for recording facing up and close
the deck by hand.
■
2
Press [
n
TAPE/CD] to switch to CD mode.
Each time you press the button:
TAPE ↔ Cd.
■
3
Press [ / K] to start recording.
CD play and recording start at the same time.
The cassette stops when the CD finishes.
To stop recording
Press [n TAPE/CD].
■
D
To pause recording
Press [ / K].
Press again to resume recording.
To continue recording from another CD on the same cas-
sette
1 Press [0 CD] and replace the CD.
2 Press [ / K].
To record selected tracks
1 Do step
■
1., then program the tracks (
\
page 12).
2 Press [ / K].
To skip unwanted tracks
1 Press [ / K] to pause recording (the CD also pauses).
2 Tu rn [TIME/PRESET TUNE CD SKIP ] so the next track you
want to record is displayed.
3 Press [ / K] to resume recording.
■
C
7
A
To protect tapes against further recording
7
B
7
2
7
1
7
3
7
C
7
3
7
1
7
2
DECK
TAPE ⁄ CD
Side to be recorded facing up
Insert the cassette with the exposed tape facing you.
1
32
7
D
Recording
Tab for side “B”
Tab for side “A”
Side A
Normal position tape
To re-record
A
Adhesive
tape