Filter
Top Products
RQT6341
3
1
Switch [ ] to “TUNER”.
(Unit comes on.)
2
Press [BAND] to select “FM” or “AM”.
3
(Omit this step if using the remote control)
If “ ” is on the display, press
[TUNE MODE] to clear it off.
4
Press [–/g] or [f/+] to
tune to the desired station.
The frequency changes one step
each time a button is pressed.
Automatic tuning
Keep [–/
g] or [f/+] depressed and release when the frequency
display starts to change. A station with good reception is automati-
cally selected and the process stops.
To stop automatic tuning, press [–/
g] or [f/+] again.
Note
Automatic tuning may stop on a frequency where there is no station if
there is interference. Press [–/
g] and [f/+] to tune if this occurs.
5
Adjust the volume.
To use auto scan
You can search for a station by listening to all tuned-in stations for 8
seconds each.
Preparation: Switch [
] to “TUNER”.
1. Press [BAND] to select “FM” or “AM”.
2. Press [AUTO SCAN].
Auto scan starts.
3. Press [AUTO SCAN] when you find the desired station.
Auto scan ends when it reaches the original frequency again.
To stop during the process, press [AUTO SCAN].
To improve reception
FM: Extend the whip antenna and adjust its direction.
AM: Adjust facing of the unit.
If noise is excessive in the FM stereo mode
Press [FM MODE]. (“
” lights up.)
Sound will be produced in monaural, but this also reduces noise.
Press the button again to cancel. (“
” goes out.)
Preset the stations (twelve FM and twelve AM) to make tuning simpler.
Preparation: Tune to the desired station.
(Do steps 1–4 on the left.)
1
Press [MEMORY].
2
While “ ” and the frequency are
flashing
Press [MEMORY].
3
While “ ” and the preset channel
are flashing
Press [–/g] or [f/+] to
select the desired channel.
(Remote control: [
44
44
4] or [
33
33
3])
4
Press [MEMORY].
(This completes presetting.)
Repeat the above to preset other stations.
Note
If “
” goes off during presetting, return to step 1.
Press [BAND] to select “FM” or “AM”.
(Omit this step if using the remote control)
Press [TUNE MODE] to display
“
”.
Press [–/
g] or [f/+] to select
the desired channel (1–12).
(Remote control: [
44
44
4] or [
33
33
3])
To use preset scan
You can search for a station by listening to all preset channels for 8
seconds each.
1. Do steps to above.
For remote control, replace [– /
g] or [f/+] described below with [
44
44
4]
or [
33
33
3].
2. Press and hold [–/
g] or [f/+] until “PS” appears on the display.
3. Press [–/
g] or [f/+] when you find the desired channel.
Preset scan ends after searching through each preset channel once.
To stop during the process, press [–/
g] or [f/+].
Normal tuning Preset tuning
The Radio
To listen to preset channels
How to preset
Indicates
auto scan
Indicates
preset scan
“ ” lights when an FM stereo
broadcast is being received.
Preset channel
Preset channel
3
2
15 4
1
2
3
124 3
P3-4 11/21/01, 7:05 PM3